Instruction Manual

9
UNITS WITH TIMER
How to use the timer
To program heating, proceed as follows:
- Look at the time on your clock or watch. If it is 10 p.m.,
turn the numbered timer disk clockwise until the
number 22 (10 p.m.) on the disk coincides with the
pointer s (3) on the timer. Set the periods of time
when you want the appliance to work by pushing the
teeth (1) inward. Each tooth (1) corresponds to a period
of 15 minutes. This will leave visible sectors which
correspond to the periods of operation (2). When set,
the radiator will operate automatically each day during
the times programmed (important: the radiator must
always be plugged into the socket).
- To change the programming, move the teeth back into
the initial position and set the new periods of operation.
- If you want to make the appliance operate without
programming, push all the teeth inward. In this case, to
turn the appliance o completely, as well as turning the
dial to the o position, you must also unplug it from the
power outlet to avoid continued operation of the timer.
IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-
CLOCKWISE.
The timer is like an electric clock, and will only work when
plugged into a power supply. When unplugged, the timer
stops and must be later re-set.
SAFETY DEVICE
A safety device switches the heater o in the event of
overheating. To restart the heater, call the nearest De'Longhi
Customer Service.
MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow
the radiator to cool. Wipe radiator with a soft damp cloth;
do not use detergents or abrasives. Should the radiator not
be in use over a certain length of time, wind the cord around
the holder and store it in a dry place. This appliance has been
built to last for many years of trouble-free service. In case
of malfunction or doubt, do not try to repair the heater by
yourself: this might increase the risk of re and electric shock.
Call your nearest De'Longhi Customer Service (see attached
list of Service Centers).
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work - Be sure it is plugged in and that the
electrical outlet is working.
- Check for any obstruction.
- The temperature may be set too low.
- Plug into the power outlet.
- Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact the nearest
De'Longhi Customer Service.
- Set the temperature to a higher position.