instructions STRETTO Please retain these instructions for future reference
Thank you for choosing this De’Longhi heater. To get the very best out of your new heater please read these instructions before using it.This will ensure that you gain optimum results and use the appliance safely. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Never use the heater to dry laundry. - Never rest the power cable on the heater’s elements while it is hot. - Only use the heater in an upright position.
Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
General instructions 1. Remove the heater from the packaging. 2. Turn the heater upside down and rest on the polystyrene. 3. Check that neither the heater nor the power cable has been damaged in any way during transportation. 4. Do not operate the heater if damaged. 5. Your heater is suitable for either freestanding or wall mounting usage. Make sure that no pieces of polystyrene or other packaging material have been left between the elements of the appliance.
Installation wall-mounting 150mm 150mm Ceiling The wall mounting kit should contain: 2 x Upper brackets (A) 1 x Lower brackets (B) 250mm 5 x screws 1. Select position for locating the heater ensuring that: Walls/ a. It is not located directly below a power socket outlet. furnishings b. The plug and power outlet can be easily reached after installation. 150mm c. No electric cables or other tubes could be damaged. d. Keep away from curtains or inflammable materials. Also Fig.
marked holes and then insert wall plugs to suit. (For plasterboard we suggest, locating the studding and using No 6 woodscrews directly into the wood, or special plasterboard fixings. For other wall types please seek specialist advice). 5. Fix the brackets “A” onto the wall. Then hang the radiator (fig.5).
Instruction for use Using for the first time On using the appliance for the first time we advise that you turn it on to the maximum power setting for up to 8 hours. This is to eliminate the heater’s “new odour”. During this time ensure that the room is well ventilated. I II Operation and use Turning the appliance on Insert the plug into the mains socket and switch on. Turn the thermostat dial clockwise to its highest setting.
5706002300/10.