Instruction Manual

9
- The rst time you use the appliance, operate it of at
least 15 minutes with the thermostat at maximum to
eliminate the “new” smell. A little smoke due to the
protective substances applied to the heating element
before transport may be given o.
- Do not obstruct the hot air outlet grilles or the air
intake grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet
can be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in
area.
- The appliance is tted with a safety device which will
switch o it in case of accidental overheating. To reset,
please contact Customer Experience, see enclosed
guarantee.
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste
separation and recycling centre.
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
A Thermostat pointer
B Indicator light
C Timer
D Wheels
E Power selector
USE
Models with “easy wheel” system
Turn the radiator upside down and rest it on a piece of cloth
or other soft surface to avoid damaging the paint.
Open the wheels completely by rotating them outwards
(g. 1).
Turn the radiator upright.
Important
When in use, the radiator should always be kept vertical
(wheels at the bottom, controls at the top). Any other
position could be dangerous!
Connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power
supply line correspond to the load specied.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
The radiator must be connected to a perfectly functioning
230-240 V AC socket with correct poles. Avoid contact
between clothing, household linen, furniture, inammable
material and the socket providing power to the radiator.
Where to locate the appliance
Position the radiator under the coldest window in the room
or wherever else you want. The radiator will reduce the
eects of cold draughts to a minimum. The appliance must
not be positioned directly underneath a xed power point.
Do not use the appliance in rooms with a surface area of
less than 4 m².
TURNING ON
Plug into the mains, turn the thermostat pointer as far as
it will go to maximum and turn the radiator on using the
power selector as described below:
• Turn the power selector to 1 (minimum power) (the
light comes on).
• Turn the power selector to 2 (medium power) (the
light comes on).
• Turn the power selector to 3 (maximum power) (the
light comes on).
Please note: For economic operation, once the
appliance has reached working temperature, you can use
minimum or medium power (1 or 2).
Adjusting the thermostat
When the room has reached the required temperature, turn
the thermostat slowly clockwise until a "click" is heard and
no further. The thermostat will automatically regulate the
temperature set and keep it constant. If your model has
three power levels, in the spring or autumn or on mild days,
you can further save energy by using minimum power.
Fig. 1