Instruction Manual

10
Frost protection function
Turn the thermostat dial to the and select the maximum
power, the appliance maintains room temperature at about
5°C, preventing freezing with minimal energy consumption.
Please note: To turn the appliance o completely,
turn the power selector to "0".
APPLIANCE WITH TIMER
As with all clocks, the timer must be set to the exact time.
For example, if it is 9.30 in the morning, turn the dial of
the timer clockwise (in the direction of the arrow) until
9.30 is lined up with the pointer. IMPORTANT: DO NOT
TURN THE DIAL OF THE TIMER ANTICLOCKWISE. The timer is
an electric clock and works only if plugged into a socket. If
disconnected, the timer stops and must be reset.
THE TIMER
See gure below:
IMPORTANT: the timer consists of 96 teeth, each
representing a 15-minute period. The appliance can be
programmed to come on and go o at set times. With the
timer, the appliance is programmed to within 15 minute
intervals and you can programme up to 48 cycles (each
cycle consists of a coming on and a going o time) during
a 24 hour period). The teeth can be pushed or pulled with
your ngers. When a tooth is pushed towards the centre
of the dial, the radiator remains in operation for those 15
minutes.
If the tooth is pulled out, the radiator is o during that
period.
Using the timer
A) Plug into the mains socket.
B) Turn the dial clockwise to set the current time (see
SETTING THE CLOCK).
C) Push the teeth corresponding to the period you do not
want the radiator to operate towards the outside. For
example, the radiator in the gure will be on from 2.00
to 5.00.
D) Turn the power selector to the required position (1, 2
or 3).
E) Once the teeth have been set for the desired periods of
heating, the radiator will come on and go o as set.
F) While the radiator remains plugged into the socket,
the timer retains the correct time.
CUTTING OUT THE TIMER (models with selector only)
To cut out the timer, place the selector in the I position (see
gure).
To go back to programmed operation, place the selector in
the position.
Please note: when the selector is in the 0 position,
the appliance is o. In the I and 0 positions, the timer is still
set to the current time.
Safety device
A safety device shuts the radiator down in the case of
overheating. To start the radiator up again, call the nearest
service centre.
MAINTENANCE AND SERVICE
Before performing any operations on the appliance, always
unplug from the mains socket and leave to cool.
Dust the radiator with a soft damp cloth without using
detergents or abrasives.
If the radiator is not used for a long period of time, wrap
the cable around the cable tidy and store the appliance in a
dry place. This appliance has been made to last many years
without problems.
In the event of malfunction or doubt, do not try and repair
Period of
operation
Tooth
Pointer
Selector (some models only)
Manual mode
Programme mode
Appliance o