Operating instructions

Introduction

Congratulations on your purchase of this Delonghi gas cooker which has been carefully

designed and produced to give you many years of satisfactory use.

Before using this appliance it is essential that the following instructions are carefully read and

fully understood.

We would emphasise that the installation section must be fully complied with for your safety

to ensure that you obtain the maximum benefits from your appliance.

Fig. 1

Identification label

When you open the bottom oven

door the indentification label is at

the bottom right hand side.

This cooker has been designed, constructed and marketed in compliance with:

- safety requirements of EEC Directive “Gas” 90/396;

- safety requirements of EEC Directive “Low voltage” 73/23;

- protection requirements of EEC Directive “EMC” 89/336;

- requirements of EEC Directive 93/68.

Assembling the back-

guard

Before assembling remove any

protective film/adhesive tape.

The backguard B and the side

supports S and D can be found

packed in the drawer.

1. Insert the side supports S and D

into the backguard B (see fig. 1)

2. Insert the backguard group into

the support guides in the cooker

3. The backguard can be removed

for cleaning or fixed with a

screw through the hole C.