User's Manual

ANrev9 Confidential 5
Using the inReach as a
Standalone Device
You can use the inReach as a standalone device when
you don’t want to use it with an Android phone.
Power (image)
 Press and hold the Power button for three seconds
to turn the inReach on or off.
o When powered on, the Power LED will flash
green once every three seconds.
o When powering off, release the Power button
when the Power LED flashes green rapidly.
 When power is low, the Power LED flashes red
once every three seconds. This will occur when
there is only enough battery life to send 10
messages or 50 tracking points.
 When there is not enough power to send any
messages or tracking points, the Power LED flashes
red every 1.5 seconds.
Tracking (image)
The Tracking button allows you to send your location
at 10 minute intervals to explore.delorme.com when
you are using the inReach in standalone mode.
Press and hold the Tracking button for three seconds
to start or stop tracking. The Tracking LED will flash
green once every three seconds until you cancel
tracking or turn off the inReach.
Message (image)
The Message button lets you send predefined
messages that you created on explore.delorme.com
when you are using the inReach in standalone mode.
 To send predefined message one, press and hold
the Message button until the LED flashes once and
then release the button. The Message LED will flash
once every three seconds until the message is sent.
 To send predefined message two, press and hold
the Message button until the Message LED flashes
twice and then release the button. The Message
LED will flash twice every three seconds until the
message is sent.
 To send predefined message three, press and hold
the Message button until the Message LED flashes