User Manual

Document Title:
BI-NEU RTM Homologation Description
Page 3 / 5
2. Configuration and Identification of Equipment Under Test (EUT)
2.1 Description
The EUT contains circuitry and software in order to receive Long range RF data from vehicle equipped Remote
Keyless Entry Transmitters and short range RF data from Tire Pressure Wheel Sensors. The EUT demodulates
and determines whether the demodulated data should be sent to vehicle Body Control Module via a dedicated
vehicle serial bus. This EUT also generates RF data messages using vehicle status information from the CAN
serial bus for long range RF transmissions to the Remote Keyless Entry transmitters based upon receipt of a
Data request RF message.
The following are pictures of the EUT:
<Take & Insert Top & Bottom pictures of 902MHz BI-NEU Module (with housing)>
<Take & Insert picture of 902MHz BI-NEU PCB top side and bottom side>
2.2 Identification-Labeling
The following figures define the identification labeling for the EUT:
<Take & Insert Picture of BI-NEU Label attached to housing>
<Take & Insert Clear pictures of Text that is molded into the various sides of the BI Housing>
2.3 Operation Declarations
The following table provides general operation declaration information for the EUT: