Install Manual

contact bracket
contact strip
adhesive pads
antenna element in
glass
no boot
required
b.
The Contact Bracket has alignment arrows on the side opposite the adhesive pads. These arrows
indicate the contact strip location on the base of the bracket. Align the arrows with the on glass
antenna element to ensure you make direct contact between the strip and the antenna element.
c.
Remove the red liner from the adhesive pad and press the Contact Bracket firmly at the
identified mounting location on the glass. You can also view the alignment through the glass
from outside the vehicle.
d.
Once the Bracket is in place, attach the Coupling Clip to the flange on the Bracket and route any
excess cable behind liners for a clean look.
If you have an on glass FM antenna, install the Contact Bracket on the interior
window surface over the antenna element using the adhesive pad provided
and the following steps. It may be mounted either vertical or horizontal
depending on the portion of the antenna element most easily accessed.
Select a bracket position that allows room to attach the Coupling Clip and
cleanly run cables.
7.
Clean the mounting location on the glass for the Contact Bracket with the included surface
preparation kit.
a.
14 15
Internal On Glass Antenna RoutingInternal On Glass Antenna Routing