User's Manual

Setting the Alarm
To set the Alarm time, do the following:
1) Push MENU
15
button.
2) Push button
13
or until “Wake up alarm” is displayed.
3) Push button
14
to enter the Wake up alarm sub menu.
4) Push button
13
or until “Set time” is displayed.
5) Push button
14
to enter the Set time sub menu.
6) Push button
13
or to adjust the hours up or down respectively.
7) Push button
14
to set the hour and toggle to the minute adjustment.
8) Push button
13
or to adjust the minutes up or down respectively.
9) Push button
14
to save the time and finish the process.
Anti Theft Code (Guard)
The radio unit is set to function with only one vehicle. The Guard feature prohibits operation of the radio anywhere else.
The Guard is automatic and no manual handling is normally needed.
In case of malfunction
If, by some reason, the radio fails in detecting the required vehicle, the user will be prompted to enter the Anti Theft Code (sticker
found in Drivers Handbook). The display will then show “CODE 0000”.
Please note that this is a malfunction and should be checked at an authorized workshop.
To enter the code, do the following:
1) For the current (blinking) digit, turn the volume knob until the right number is shown.
2) Press the power button to enter the digit. The next digit will start to blink.
3) Repeat step 1 and 2 until all four digits has been entered.
The user has three tries to enter the code. If these are unsuccessful the radio will be locked for 60 minutes until three new tries are
allowed.
Deactivating Guard
It is possible to deactivate Guard, but (is) not recommended.
To deactivate the Guard function, do the following:
1) Push MENU
15
button.
2) Push button
13
or until “ADVANCE” is displayed.
3) Push button
14
to enter Advance sub menu.
4) Push button
13
or until “GUARD” is displayed.
5) Push button
14
to enter.
6) Push button
14
to set Guard ON or OFF.
The user will be requested for the Anti Theft Code to deactivate or activate Guard. The display will then show “CODE 0000” with the
first digit blinking.
To enter the code, do the following:
1) For the current (blinking) digit, turn the volume knob until the right number is shown.
2) Press the power button to enter the digit. The next digit will start to blink.
3) Repeat step 1 and 2 until all four digits has been entered.
The user has three tries to enter the code. If these are unsuccessful the radio will be locked for 60 minutes until three new tries are
allowed.
10
17
17
17
17
17
17
7
7