User's Manual

Repeat Tracks on a USB Device
There are three possible Repeat settings for a USB device: Repeat All, Repeat track and Repeat Folder (If the content of the USB
device is stored in folders). By default, Repeat All is active.
To change the repeat setting, do the following:
1) Press the MENU button
15
.
2) Push button
13
or until “REPEAT” is displayed.
3) Enter Random Sub menu by pressing button
14
.
4) Push button
13
or to choose between All, Track and Folder.
5) Push button
14
to activate the desired Repeat mode.
Change to another Folder on USB
If the content of the CD is stored in folders, it is possible to change folders directly. To do this, push either the button
13
or
button to move to the next or previous album/folder respectively.
Scan a USB
When USB is scanned, the first 10 seconds of each track is played.
To activate Scan, do the following:
1) Press the MENU button
15
.
2) Select “SCAN” by pressing button
14
.
Scanning will stop if
1) The face plate buttons
16
or
14
.
OR
2) All tracks are browsed through.
iPod Mode
The radio supports iPod Classic, iPod Video, and iPod nano.
The iPod settings, e.g. Shuffle or Repeat, used prior to connecting the iPod to the radio will be used by the radio.
An iPod device must be connected prior to operating in this mode.
Connecting the iPod
Connecting the iPod can be done with two different cable sets.
A split cable from the iPod 30-pin connector to a USB connector and a 3.5 mm audio connector.
A separate iPod/USB cable plus a 3.5 mm male/male stereo audio cable connected to the iPod earphone output. The iPod volume
should in this case be set to maximum prior to connecting to the radio.
When the iPod is connected to the radio, the iPod’s controls will lock. All control of the iPod is done by the radio buttons. When in
this state, the iPod will display a Volvo logotype.
Switch to iPod Mode
There are two ways to switch to iPod mode:
1) Push the CD/AUX button
12
until iPod shows on the display.
Or
2) Connect an iPod device.
Disconnecting the iPod device
No special preparations are needed to disconnect the iPod device. When the iPod device is removed the radio will play the previous
audio source.
iPod Menu
When iPod is connected and source, the user can Push and hold the
16
button to enter the iPod Menu. This Menu contains
some of the most common functions used in the iPod. E.g. the user can search for Artists and Albums, as well as starting a Playlist.
Push and hold the
16
button for 1 second to enter the iPod Menu at last used level.
Push and hold the
16
button for 2 seconds to enter the iPod Menu at top level.
16
17
17
17