DELSOL GAS GRILL INSTALLATION, USE & CARE MANUAL Models: P/N: 18930C DSBQ25 DSBQ32R DSBQ40R
A special message… Congratulations on your purchase of DELSOL gas barbecue grill. DELSOL is committed to making outdoor cooking products you’ll be proud to own for years. This manual gives you easy to follow instructions for installing, operating and maintaining your DELSOL grill. We recommend reading this manual carefully before your first use to ensure safety, proper care and operation. Keep this manual in a safe place for future reference.
IMPORTANT SAFETY INFORMATION – DELSOL GAS GRILL WARNING! Read this manual carefully and completely before using your grill to ensure proper operation, proper installation, proper servicing and to reduce the risk of fire, burn hazard and/ or other injury. DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. WARNING 1.
THIS GRILL IS FOR OUTDOOR USE ONLY: CE GRIL EST POUR UTILISATION à L’ExTéRIEUR SEULEMENT: If stored indoors, detach and leave L.P. cylinder Si l’appareil est entreposé à l’interieur, enlever outdoors. les bouteilles et les laisser à l’extérieur. GENERAL SAFETY REQUIREMENTS: 1. The installation of this appliance must conform with local codes or, in the absence of local codes; either the National Fuel Gas Code, ANZI Z223.1/NFPA 54, or the CAN/CGA-B149.1, Natural Gas Installation Code or CAN/CGA-B149.
TABLE OF CONTENTS – DELSOL GAS GRILL GETTING STARTED…………………………………………………………………… ….. 1 GAS REQUIREMENTS o GAS SAFETY REQUIREMENT……………………………………………... 3 o LP GAS HOOKUP………….………………………………………………… 4 o PORTABLE LP CONNECTION………….………………………………….. 5 o NATURAL GAS INSTALLATION………………………………………….. 6 o LEAK TEST…………………………………………………………………… 8 BURNER FLAME / AIR SHUTTER ADJUSTMENT........................................................... 9 LOCATING THE GRILL o CLEARANCE TO COMBUSTIBLE CONSTRUCTION……………………...
GETTING STARTED – DELSOL GAS GRILL 1. Remove all packaging materials, labels and protective plastic film. DO NOT LEAVE UNIT UNDER THE SUN WITH PROTECTIVE PLASTIC FILM ON FOR A LONG PERIOD OF TIME AS IT WILL BECOME DIFFICULT TO REMOVE THE FILM. 2. Check to ensure that all grill accessories listed below are included. DSBQ 25 3 3 1 (1) 1 Grill Accessories Grate, Stainless Steel Briquette Tray Assembly Regulator, NG (NG Grills Only) Regulator, LP (LP Grill ONLY) Warming Rack, (s/s) DSBQ 32R 4 4 1 (1) 1 3.
GETTING STARTED – DELSOL GAS GRILL 5. Get familiar with the knobs and burners identification below. DSBQ25 DSBQ32R Grill Burner Grill Burner Rotisserie Burner Sear Zone (Opt) Grill Burner DSBQ40R Grill Burner Rotisserie Burner Grill Burner Infrared Rotisserie Burner located on the rear panel above the grates. (32R & 40R Models Only) Straight Burner (Standard) located underneath the briquette trays.
GAS SAFETY REQUIREMENTS – DELSOL GAS GRILL Each appliance is set and tested at the factory for the type of gas supply to be used. Identify the type of gas, either Natural Gas or LP gas and make sure that the marking on the data plate (rating plate) matches the gas being supplied to the grill. The data plate is located on the rear panel of the grill. All gas connections should be made by a qualified technician and in accordance with local codes and ordinances.
LP GAS HOOK-UP – DELSOL GAS GRILL DELSOL grill for the use of LP gas comes equipped with its own regulator, which MUST NOT be removed. Install the factory-supplied hose and regulator assembly as shown. Connect the 3/8” flare end of the hose to the grill coupling using a ¾” open wrench. Do not apply pipe sealant to the 3/8” flare connection. Connect the regulator to the LP cylinder hand tighten it, do not use a wrench. Check for leaks using soapy water solution. (Reference page 8 for leak test procedure).
PORTABLE LP CONNECTION – DELSOL GAS GRILL NOTE: USE ONLY A 20-LBS. (5-GALLON CAPACITY) GAS CYLINDER. WARNING: DO NOT PLACE MORE THAN ONE CYLINDER IN THE BASE CABINET ENCLOSURE AT ANY TIME. WARNING: DO NOT USE A DENTED OR RUSTED LP CYLINDER. NEVER USE A CYLINDER WITH A DAMAGED VALVE. ALWAYS CHECK FOR LEAKS AFTER CHANGING THE LP CYLINDER. (Page 8) THE HIGH PRESSURE LP REGULATOR AND HOSE (SOLD SEPARATELY) MUST BE USED WITHOUT ALTERATION.
NATURAL GAS INSTALLATION – DELSOL GAS GRILL The installation must conform with local codes or, in the absence of local codes, with either the national Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CGA-B149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code. 1. This gas appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at the test pressures in excess of 1/2 psi (3.5 kPa). 2.
NATURAL GAS INSTALLATION – DELSOL GAS GRILL A typical Natural Gas installation is shown below. Make sure that the factory-supplied regulator is used and installed with the arrow mark on the regulator pointing towards the gas grill. Do not use any replacement regulator other than that specified by DELSOL. Use only pipe sealants that are approved for use with Natural and LP gases. An installer-supplied gas shutoff valve must be installed in an accessible location.
LEAK TEST – DELSOL GAS GRILL CAUTION BEFORE TESTING Finding and/or fixing a gas leak is NOT a “DO-IT-YOURSELF” procedure. NEVER USE THE GRILL WITHOUT FIRST LEAK TESTING THE GAS CONNECTIONS. WARNING: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS. USE OF AN OPEN FLAME COULD RESULT IN A FIRE, EXPLOSION, BODILY HARM OR DEATH. DO NOT SMOKE WHILE PERFORMING THE LEAK TEST! To prevent fire or explosion hazard, DO NOT use or permit sources of ignition in the area while performing a leak test.
BURNER FLAME / AIR SHUTTTER ADJUSTMENT – DELSOL GAS GRILL Each grill burner is tested and adjusted at the factory prior to shipment; however, variations in the local gas supply may make it necessary to adjust the burners. The flames of the straight burners should be visually checked. Flames should be blue and stable with little to no yellow tips, no excessive noise or lifting.
LOCATING THE GRILL – DELSOL GAS GRILL This gas appliance is designed and certified for outdoor use only. Do not locate this grill under overhead combustible surfaces. Do not operate the grill inside a building, garage, recreation vehicle or any enclosed area. When choosing an area, consider exposure to wind, proximity to traffic paths and length of gas supply line. Keep gas supply lines as short as possible to reduce pressure drop.
GRILL CUT-OUT DIMENSIONS – DELSOL GAS GRILL The island must be made out of non-combustible material. In an event it is combustible, the use of an insulating jacket is required.
ASSEMBLY INSTRUCTIONS – DELSOL GAS GRILL The DELSOL Grill is produced fully assembled and tested in the factory and requires no major assembly in the field. For the purpose of safe shipping and transit, some parts such as the briquette trays and rotisserie components are wrapped inside the grill and require minor assembly. Check to ensure that all packaging material have been removed prior to grill operation. TO INSTALL BRIQUETTES TRAYS 1.
ASSEMBLY INSTRUCTIONS – DELSOL GAS GRILL OPTIONAL DELSOL ROTISSERIE KIT ASSEMBLY (DSRS-KIT) 1. Install the bracket as shown in figure 1. 2. Install the rotisserie motor as shown as shown in figure 2. The motor socket hole will line up with the notch of the rear hood. 3. Remove the stainless steel grates. 4. Place a basting pan on top of the briquette trays to catch the drippings. (basting pan not supplied) 5. Insert the meat fork and the balancer (figure 3) and spit rod saddle (figure 4) into the spit rod.
OPERATING INSTRUCTIONS – DELSOL GAS GRILL BEFORE LIGHTING THE GRILL DO NOT ATTEMPT TO LIGHT THE GRILL IF YOU SMELL GAS. WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED WITH THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS. If not properly installed, gas may leak outside of the burner that could lead to fire, potential damage to your grill, bodily injury or death. Inspect the gas supply piping or hose prior to turning the gas ON.
OPERATING INSTRUCTIONS – DELSOL GAS GRILL Match/BBQ Lighter Lighting Instructions: If spark igniter will not light the burners, the burners can be lit manually using a lit long match, taper or BBQ lighter. 1. Push and turn the knob counter-clock-wise to the biggest flame marking on the bezel. 2. Using the provided match holder located on the drip pan, insert a lit match or BBQ lighter thru the grates and near the top of the burner. Once you see or hear a flame you can release the knob.
OPERATING INSTRUCTIONS – DELSOL GAS GRILL USING THE ROTISSERIE BURNER (For DSBQ32R & DSBQ40R Units) The Rotisserie system rotates the food in front of infrared burner heat for even cooking and juicier taste. 1. Install the rotisserie motor on the motor bracket and plug it in to proper voltage. 2. Insert the food on the middle of the spit rod and then secure it with the meat holders on both ends by tightening the thumb screws on the meat forks.
GRILLING IN WINDY CONDITIONS – DELSOL GAS GRILL Outdoor grills produce more heat than interior kitchen ranges. That is how they sear and grill steaks and other food. These high performance burners require a constant steady supply of fresh air to mix with fuel. The grill is designed to pull air in through the front and vent hot gases out through the rear. Using grill in windy conditions may disrupt the front-to-back air flow.
CLEANING & MAINTENANCE – DELSOL GAS GRILL STAINLESS STEEL The DELSOL grill is made of all stainless steel. It is non-rusting and non-magnetic. Never clean the stainless steel when it is hot. After the initial grilling use, certain areas of the grill may discolor. This is a normal discoloration caused by the intense heat given off by the burners. Specks of grease can gather on the surface of the stainless steel and get baked-on.
CLEANING & MAINTENANCE – DELSOL GAS GRILL BURNERS Burners are made of heavy gauge stainless steel and can be soaked in water and cleaned with a wire brush. Check every port hole for clogs. Use a wire pin to clean out clogged ports. Make sure the burner is dry before installing it back into the grill. DRIP PAN The drip pan collects grease, liquid and fallen food particles. Allow the pan and its contents to cool before cleaning. Slide the pan out and wipe it clean.
TROUBLESHOOTING GUIDE – DELSOL GAS GRILL BEFORE CALLING FOR SERVICE: If your DELSOL grill does not function properly, use the following troubleshooting guide before contacting your dealer for service. The troubleshooting guide may save the cost of a service call and the inconvenience of being without your grill. PROBLEM Grill will not light. WHAT TO DO 1. 2. 3. 4. Push in, turn the knob clockwise, and verify that the spark igniter functions. Purge the line of any trapped air.
EXPLODED VIEW – DELSOL GAS GRILL 21
REPLACEMENT PARTS LIST – DELSOL GAS GRILL Item No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 TE Part No.
REPLACEMENT PARTS LIST – DELSOL GAS GRILL Item No. 54 55 56 57 58 TE Part No.
DELSOL GRILL WARRANTY TEN YEAR LIMITED WARRANTY: DELSOL warrants the stainless steel grates, stainless steel burner, and fabricated stainless steel housing to be free from defects in materials and workmanship under normal residential use for ten years from the original date of purchase. This warranty excludes grills used in rental or commercial applications.
HOW TO OBTAIN SERVICE For service, please contact your DELSOL dealer or call DELSOL Grills direct at (562)802-3488 or fax (562) 802-3391 Mailing address: DELSOL Grills 13259 166th Street Cerritos, CA 90703 Please provide: Model number Serial Number Date of installation A description of the problem Cut Here Warranty Registration Customer Name Model # Address Serial # City Date Purchased Zip Dealer’s Name Phone # Dealer’s Address e-mail: This Warranty Registration card must be returned wi
Cut Here Place Postage Here Customer Service ATTN: Warranty Department 13259 166th Street Cerritos, CA 90703