Instruction manual

20 - English

STORING THE RIP FENCE

You can store the rip fence (B) Fig. 48

on the holder bracket.

STORING THE MITER GAUGE

AND WRENCH

The two holder brackets hold the miter

gauge (C) and and the blade changing

wrenches (D) Fig. 49.

Common sawing operations include ripping and cross cutting plus a few other standard operations of a fundamental

nature. As with all power machines, there is a certain amount of hazard involved with the operation and use of the

machine. Using the machine with the respect and caution demanded will considerably lessen the possibility of personal

injury. However, if normal safety precautions are overlooked or completely ignored, personal injury to the operator

can result. The following information describes the safe and proper method for performing the most common sawing

operations.

This instruction manual does not provide information regarding the installation of a fence system. A

fence system must be installed before use of the saw. Please refer to the fence instruction manual regarding the

proper installation, alignment and operation of the fence system.

The use of attachments and acces sories not recommended by Delta may result in injury.

Never operate the saw without the proper table insert for the saw blade or cutter installed.

NOTE: The photos in this "MACHINE USE" section are meant to show technique only. They may not look like

your saw.

MACHINE USE

QUICK OPERATIONS CHECKLIST

Before using the saw each and every time, verify the following:

1. Blade is tight.

2. Bevel angle and height lock knobs are tight.

3. If ripping, ensure fence lock lever is tight and fence is parallel to the blade.

4. If crosscutting, miter gauge knob is tight.

5. Proper eye, hearing and respiratory equipment is being used.

6. The blade guard is properly attached and the anti-kickback pawls are functioning.

Failure to adhere to these common safety rules can greatly increase the likelihood of injury.

Fig. 49

Fig. 48