Instruction manual

26
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
MAINTENANCE
REPLACEMENT PARTS
When servicing use only identical replacement parts. Check
the parts list included for more information. Parts lists can
also be found online at www.deltamachinery.com.
SERVICE AND REPAIRS
All quality tools will eventually require servicing, or
replacement of parts due to wear from normal use. For
assistance with your tool, visit our website at www.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They
could possibly dissolve or otherwise damage the material.
WEAR ANSI Z87.1 SAFETY GLASSES
WHILE USING COMPRESSED AIR.
FAILURE TO START
Should your machine fail to start, check to make sure
the prongs on the cord plug are making good contact
in the outlet. Also, check for blown fuses or open circuit
breakers in the line.
LUBRICATION
Apply household floor paste wax to the machine table
and extension table or other work surface weekly.
PROTECTING CAST IRON FROM RUST
To clean and protect cast iron tables from rust, you will
need the following materials: 1 pushblock from a jointer,
1 sheet of medium Scotch-Brite™ Blending Hand Pad,
1 can of WD-40
®
, 1 can of degreaser, 1 can of TopCote
®
Aerosol. Apply the WD-40
®
and polish the table surface
with the Scotch-Brite pad using the pushblock as a
holddown. Degrease the table, then apply the TopCote
®
accordingly.
SERVICE
deltamachinery.com for a list of service centers or call
the Customer Care Department at 1-800-223-7278. All
repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot
guarantee repairs made or attempted by others. Should
you have any questions about your tool, feel free to write
us at any time. In any communications, please give all
information shown on the nameplate of your tool (model
number, type, serial number, etc.).