Installation Guide

5
ASSEMBLY INSTRUCTIONS
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
dna seerged 09 ot tuo sbat gnisuoh eht dneb oT .1
make housing tabs contact the bottom of the joist.
(ø 4x25).
tapping screws 4 htiw stnuom gnisuoh ehT .2
Screw housing to joist through lowest holes
in each mounting flange, then through the
other holes.
3.
NEW CONSTRUCTION
1
3
Joist
Tapping Screw
MOUNT HOUSING WITH FLANGE:
USING HANGER BARS
Insert hanger bars into the channels on housing.
Sliding hanger bars to allow for your
specific positioning of housing anywhere
between joists and span up to 24”.
4. Extend hanger bars to the width of the
joists. Make sure the fan body is level and
perpendicular with the joist, and flush with
ceiling surface. Fasten hanger bars to
joists with tapping screws (ø 4×25). Secure
hanger bars together with machine screws
(#8-32 x 5/16”).
2
4
Tab
Joist
Hanger Bar
Channel
Screw
Joist
Joist