Specifications

VFD-G Series

5-31

09 Hardware protection failure (HPF)

10 Over-current during acceleration (OcA)

11 Current exceeds 2 times rated current during decel. (ocd)

12 Current exceeds 2 times rated current during steady state

operation (ocn)

13 Ground fault (GFF)

14 Low voltage (Lv)

15 CPU READ failure (CF1)

16 CPU WRITE failure (CF2)

17 Base Block (bb)

18 Motor over load (oL2)

19 Reserved

20 Software/password protection (codE)

21 Emergency stop (EF1)

22 Phase-Loss (PHL)

23 Low-current (Lc)

24 Feedback Loss (FbL)

25 Reserved

06 - 15 Parameter Reset Factory Setting: 00

Settings 00~65535

09: Reset parameters (50Hz, 380)

10: Reset parameters (60Hz, 440)

 This parameter resets all parameters to the factory setting.

06 - 16 Parameter Protection Password Input Factory Setting: 00

Settings 00~65535

 This parameter allows the user to enter their password to unlock the Parameter Protection

feature. The password entered must match the value entered into Pr.6-17. After three

invalid password attempts, the drive will no longer allow any operation. The drive must then

be powered off and back on again.

 After successfully entering the password, the user may change parameters as they wish.

Once the drive is powered off, the drive has locked the parameters again. To clear the

password, the user must enter the correct password in Pr.6-16 and then set Pr.6-17 to 00.