User manual

Chapter 8 Summary of Parameter Settings
© 1999 DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
111
Group 6 Protection Parameters
Parameters Explanation Settings
Factory
Setting
d7: CPU Fault (cF3)
d8: Hardware Protection failure (HPF)
d9: Current exceed during Acceleration (ocA)
d10: Current exceed during Deceleration
(ocd)
d11: Current exceed during Steady State
(ocn)
6-10
Third Most Recent
Fault Record
d12: Ground Fault (GF)
0
Group 7 Motor Parameters
Parameters Explanation Settings
Factory
Setting
7-00 Motor Rated Current H 30 to 120% 85
7-01
Motor No-Load Current
H
0 to 90% 50
7-02
Torque Compensation
H
0 to 10 3
7-03 Slip Compensation H 0.0 to 10.0 0.0
Group 8 Special Parameters
Parameters Explanation Settings
Factory
Setting
8-00
DC Braking Voltage
Level
0 to 30% 0
8-01
DC Braking Time
during Start-Up
0.0 to 60.0 Sec 0.0
8-02
DC Braking time
during Stopping
0.0 to 60.0 Sec 0.0
8-03
Start-Point for DC
Braking
0.0 to 400 Hz 0.0
8-04
Momentary Power
Loss
d0: Stop Operation after Momentary Power
Loss
0