User manual

Chapter 5 Description of Parameter Settings

2 - 01 Source of Operation Command Factory Setting: d 0

Settings d 0 Controlled by the keypad

d 1 Controlled by the external terminals, keypad STOP

enabled.

d 2 Controlled by the external terminals, keypad STOP

disabled.

d 3 Controlled by the RS-485 communication interface,

keypad STOP enabled.

d 4 Controlled by the RS-485 communication interface,

keypad STOP disabled.

& When the AC drive is controlled by an external source, please refer to

parameter group 4 for detailed explanations on related parameter settings.

2 - 02 Stop Method Factory Setting: d 0

Settings d 0 Ramp stop

d 1 Coast stop

& The parameter determines how the motor is stopped when the AC drive

receives a valid stop command.

1. Ramp: the AC drive decelerates the motor to Minimum Output Frequency

(Pr.1-05) and then stops according to the deceleration time set in Pr.1-10 or

Pr.1-12.

2. Coast: the AC drive stops output instantly upon command, and the motor

free runs until it comes to a complete stop.