User manual

Chapter 5 Description of Parameter Settings
© 1999 DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
38
CH 5-4 Group 3: Output Function Parameters
3 - 00 Analog Output Signal Factory Setting: d 0
Settings d 0 Analog frequency meter (0 to Maximum Output
Frequency).
d 1 Analog current meter (0 to 250% of the rated AC
drive current).
& This parameter selects either Output Frequency or current to be displayed
using the 0 to10V AFM output.
3 - 01 Analog Output Gain Factory Setting: d100
Settings d 1 to d 200% Unit: 1%
The parameter can be set during operation.
& The parameter sets the voltage range of analog output signal (frequency or
current), on output terminal AFM.
The analog output voltage is directly proportional to the output frequency of the AC
drive. With the factory setting of 100%, the Maximum Output Frequency (Pr.1-00)
of the AC drive corresponds to +10VDC analog voltage output. (The actual voltage
is about +10VDC, and can be adjusted by Pr.3-01)