User manual

Chapter 5 Description of Parameter Settings

The analog output voltage is directly proportional to the output current of the AC

drive. With the factory setting of 100%, the 2.5 times rated current of the AC drive

corresponds to +10VDC analog voltage output. (The actual voltage is about

+10VDC, and can be adjusted by Pr. 3-01)

Note: Any type of voltmeter can be used. If the meter reads full scale at a voltage

less than 10 volts, then Pr.3-01 should be set by the following formula:

Pr.3-01 = ((meter full scale voltage)/10) ×100%

For Example: When using the meter with full scale of 5 volts, adjust Pr.3-01 to

50%

3 - 02 Desired Frequency Attained Factory Setting: d 1.0

Settings d 1.0 to d 400 Hz Unit: 0.1Hz

& If a Multi-function output terminal is set to function as Desired Frequency

Attained (Pr.3-05 or 3-06=d9), then the output will be activated when the

programmed frequency is attained.