Datasheet

TECHNICAL DATASHEET
CliQ DIN Rail Power Supply
12V 15W 1 Phase / DRP012V015W1A□
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (September 2013, Rev. 03)
7
Output De-rating VS. Input Voltage
■No output power de-rating across the entire input
voltage range
Assembly & Installation
The power supply unit (PSU) can be mounted on 35mm DIN rails in accordance with EN60715. The device should be installed horizontally
with input terminal blocks on the bottom.
Each device is delivered ready to install.
Mounting
Dismounting
Snap on the DIN rail as shown on the left:
1. Pull the DIN rail’s latch OUT.
2. Tilt the unit upwards, hook the top end of
onto the DIN rail and push downwards until
stopped.
3. Position the bottom front end against the DIN
rail.
4. Push the unit’s latch DIN rail IN to lock.
To uninstall:
1. Pull the unit’s DIN rail latch OUT.
2. Tilt the bottom part of the unit out.
3. Push the unit up and pull out from the DIN rail.