Bescheinigung des Her Stellers / Importeurs Hiermit wird bescheinigt , da 8 der/ die/ das in Ufereinstimmung mit den Bestimmungen der (Amtsblattverfügung ) Funk-entstort ist. Der Deutschen Bundespost wurde das (Inverkehrbringen dieses Grates angezeigt und die Berechtigung zur Übersprungen der Serie auf Einhaltung der Bestimmungen eingerahmt.
Federal communications commission (FCC) Statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications.
IMPORTANT SAFETY INSTRUCTIONS I. w. SEE INSTALLATION INSTRUCTIONS BEFORE CONNECTING TO THE SUPPLY. THE APPLIANCE COUPLET 1S CONSIDERED AS A DISCONNECT DEVICE. SHALL BE CONNECTED AS CLOSELY AS PRACTICABLE TO THE INCOMING SUPPLY. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
INTRODUCTION Our monitors is high resolution color monitors for use with \BM PC/XT/AT and PS/2 computers or compatibles with analog RGB output The monitors support timings of graphics adapters including: VGA, super VGA, 8514/A, XGA, 1024x768,1280x1024 and 1600x1200 FEATURES Automatically scan horizontal and vertical frequencies. Analog input signal provides the capability of unlimited display colors. Auto sizing and auto centering between modes of graphics standards.
INSTALLATION INSTRUCTIONS CAUTION: Be sure to turn off the AC Power to the monitor before making connections. 1 Assemble the tilt/swivel base as shown below. 2.Connect the power cord as shown on page 8 3. Connect the end of the signal cable to the display connector of computer and tighten the screws as Shawn on page 8.
USING THE RIGHT POWER CORD FOR 230VAC For units used at 120V:Use a UL Listed cord set consisting of a minimum No.18 AWG, Type SVT or SUT, rated 6A minimum 125V, three-conductor cord a maximum length and a parallel blade, grounding type attachment plug For units used at 230V (domestic a UL Listed cord set consisting of a minimum No. 18 AWG, Type SVT or SJT, rated 3A minimum 250V, three conductor cord a maximum length and a tandem blade, grounding type attachment plug. For units used at 230V (outside of U.
CONTROLS AND OPERATION 1. TILT/SWIVEL BASE Turn the monitor for comfortable viewing angle within 180 degrees horizontally and 20 degrees vertically. (Please refer to instructions on bottom of rear cover for installation.) 2. AC INPUT CONNECTOR (Appliance couplet) Connect to AC outlet with supplied power cord. 3. SIGNAL INPUT CONNECTOR (15-pin mini D-SUB) Connect to the display adapter output of a computer having analog video output. (Please see installation instructions.) 4.
OSD MANUAL --BASIC -CONTRAST “BRIGHTNESS -H-SIZE -H-POSITION -V-SIZE -V-POSITION -RECALL ESC --GEOMETRY -PINCUSHION “TRAPEZOID -PIN-BALANCE PARALLEL -ROTATION -MOIRE -DEGASSED RECALL ESC --COLOR -9300 / 6600 / 6500 --STATUS --DOSS FUNCTION -POSITION -POSITION £3 -ESC -LANGUAGE ( ENGLISH / FRENCH /GERMAN / SPANISH / ITALIAN EXIT NOTE: 1. To enter OSD: push “1 OR 2" bottom 2 Expositor: 1. two keys simultaneously or 2. Select “exit” button 3.
POWER MANAGEMENT THIS MONITOR CAN SUPPORT VASE POWER MANAGEMENT SYSTEM, INDICATED BY THE LED ON THE FRONT PANEL: (Eb POWER STATE COLOR | CONSUMPTION ON GREEN STANDBY/ | AMBER A5W SUSPEND OFF AMBER BW This monitor remains in the power-saving state until you press a key on the keyboard or move the mouse {if available) DISPLAY DATA CHANNEL (DDC) COMMUNICATION CHANNEL TYPE: VASE DDG 1/28. ESTABLISHED TIMINGS: AS PRESET TIMING CHARTS.
SPECIFICATIONS MODEL SIZE F CRT | i DEFLECTION ANGLE DA-795 UAP 17 INCH DIAGONAL {18° VIEWABLE) 90 DEGREES _ SCREEN GRAPHICS STANDARDS COMPATIBILITY RESOLUTION (MAX) PHOSPHOR PITCH _ _ opossum DOT TYPE NON-GLARE XGA, SUPER VGA, VGA 1600x1200 NON-INTERLACED HON. INTERLACED 1500x1200, 1280x1024.
SPECIFICATIONS I MODEL 1 DA-795 UAT | T SIZE 17 INCH DIAGONAL VIEWABLE) i I" DEFLECTION ANGLE 90 DEGREES | CRT | | i PHOSPHOR PITCH D.25MM ! | | SCREEN DOT TYPE NON-GLARE 3 GRAPHICS STANDARDS INTERLARDED 1600x1200, | COMPATIBILITY _ XGA, SUPER VGA, VGA, Bb { Solutes OAR | 1500x1200 NON-INTERLACED ! VIDEO BANDWIDTH i J50MHZ (DOT RATE) [enamor TT HORIZONTAL 30-85KHZ.
SPECIFICATIONS r MODEL DATES KAT 1 SIZE 17 INCH DIAGONAL | ! (16” VIEWABLE) REFLECTION ANGLE | 20 DEGREES | CRT PHOSPHOR PITCH 0.25MM SCREEN TT DOT TYPE NON-GLARE | [GRAPHICS STANDARDS INTERFACED 16001200, 1260¢10241024x768 COMPATIBILITY T XGA, SUPER VGA VGA i. RESOLUTION (MAX) i 1500x1200 NON-INTERLACED VIDEO BANDWIDTH T50MHZ | _ (DOT RATE) 1 I SYNCHRONY HORIZONTAL 30~95KHZ.
INPUT PIN ASSIGNMENT PIN NO.
DELTA ELECTRONICS, INC. ES-DA-795 BAP 0001 03/16/1998 Model Picture Tube TSB 17” Flat Square Tube (FIST, 90 degree deflection, 0.25mm dot pitch, micro Fitter, anti-glare, anti-static, P22 phosphor, medium short persistence. Signal Input Interface Video: RGB analog Synge: H. V. Separate Sync H. V.
DELTA ELECTRONICS, INC. ES-DA-795 BAP 0001 03/16/1998 REV .:P0 Engineering specifications (1) All measurements shall be made after 30 minutes warm-up. (2) All tests shall be performed under normal operating conditions of rum temperature 25°C unless otherwise specified. (3) CRT shall face east. 1.0 Power input 1.1 Power supply Switching type power supply. Input voltage: 90-264Vac universal Frequency: 47-63 Hz. 1.2 Power consumption 130W max. 1.
DELTA ELECTRONICS, INC. 2.0 Video interface and video output 2.1 Input signal connector 15 pin mini D-sub connector pin number pin function 1 Red video input 2 Green video input 3 Blue video input 4 Ground 5 No connection 6 Red video ground 7 Green video ground 8 Blue video ground 9 No connection 10 Ground 11 Ground 12 SDA 13 Horizontal sync {Composite sync) 14 Vertical sync 15 SCL 2.2 Signal input voltage Video: Analog Sync: TTL level 2.3 Video bandwidth 150MHz (-3db) nominal 2.
DELTA ELECTRONICS, INC. 2.6 Contrast control Brightness control 3.0 Deflection 3.1 Synchronization 3.2 Retrace time 3.3 High voltage ES-DA-795 BAP 0001 04/01/1998 Video gain control from 20% to 100%. Background raster control by adjust G1 voltage. Horizontal: ~~ 30-kHz Vertical: 50-160 Hz. Horizontal: 2.3ps typical. Vertical: 300us typical. 26KV typical (at cut-off) 3.4 Raster regulation (for all modes) Li: L2: 3.5 Picture size 300 reverse video xX 225 mm rr L2-L1 0% Li Picture width at brightness with 5fl.
DELTA ELECTRONICS, INC. Position control range 3.7 Centering 3.8 Linearity (for all modes) Formula for linearity: X = average 40 CRT display performance 4.1 Total geometry distortion Pincushion distortion Barrel distortion S-curve 4.2 Til Orthogonality Horizontal: 20mm min. Vertical: 20mm min. Horizontal: 4.0mm max. Vertical: 4.0mm max. Horizontal: <=10% Vertical: <=10% (Max-Min)/ X x100% Sides 2.0mm Top/bottom 2.0mm Sides 1.0mm Top/bottom 2.0mm Sides 1.0mm Top/bottom 2.0mm Sides 1.0mm d € + 1.
DELTA ELECTRONICS, INC. 4.3 Convergence 4.4 Brightness uniformity 4.5 Purity 4.6 White balance 4.7 Focus 4.8 Sitter & swim ES-DA-795 BAP 0001 03/16/1998 Zone A: 0.3mm Zone B: 0.4mm Zone B Ole 300 X Zone A ~ 223 mm B Cc 300 X A 225 A=301 B(CDOE) 700, A Won't be noticeable after manual degassing regardless of what direction the CRT faces, Full light output 9300 degree K 6500 degree K 5500 degree K + 10% + 10% + 10% £ 10% Background + 10% 311 £10% When inspection focus in “F&” pattern at max.
DELTA ELECTRONICS, INC. ES-DA-795 BAP 0001 03/16/1998 4.9 More On screen display control 5.0 Reliability, environment, & packing test 5.1 MT BF 50,000 hours Demo. (excluding CRT) 52 Ambiance Operating temperature: 0-40°C Storage temperature: -20-60°C Humidity: 10-90% 5.3 Vibration test Delta standard Drop test Delta reinforced standard 6.0 External controls & indicators Front: 1. Power switch 2. Power LED 3. 4-key On-screen display control On display control: 1. _ [Contrast 11. Rotation 2. |Brightness 12.
DELTA ELECTRONICS, INC. ES-DA-795 BAP 0001 03/16/1998 REV..Pg Regulatory Approvals Safety UL 1950 CSA 22.2 NO. 950-M89 EC, EN 60 950 (TUV GS) EMI FCC for CE product MPR II X-ray FDA DHS 21 CFR Sub chapter J 8.0 Power Management 8.1 On Definition of Modes There are three modes of operation for the DA795. These are ON, SUSPEND, and OFF. Both Horizontal and Vertical Syncs are present and the monitor is in normal operation. Suspend Horizontal or Vertical sync is inactive per VASE DIMS spec. and not operational.
DELTA ELECTRONICS, INC. ES-DA-795 BAP 0001 03/16/1998 Power Management Power A Recover Recover time time ~ sec, ~ sec. 100% Suspend Mode Hor V i
