User's Manual

27
Step 13. After pressing the “SUBMIT” or “REACTIVE”, you can see the message
“PLEASE AWAIT CONFIG” display on LCD. The time count is depending on
your PV micro inverter numbers to connect with DDP.
The power information displays after time counting finishes.
Attention
The DDP connects with PV micro inverters by using the power line
communication (PLC) method. It takes some times to connect, but it doesn’t
connect successful because the PLC can’t verify success. So, it will display two
statuses as bellow if time count has finished.
Status 1： It connects successful if LCD displays the power information after few
minutes.
Status 2： It connects fail if LCD doesn’t display power information. For this status,
it needs to spend some time to connect again until it connects
successful. Please kindly inform our service if it always can’t display
after 20 min or above.
PLEASE AWAIT CONFIG
XX:XX
192.168.xxx.xxx Web
ID: 1 POWER:123.4W
192.168.xxx.xxx Web
ID: 1 POWER: W