User's Manual

To install the Bracket on DIN Rail, please follow the steps below.
1. Clip the top side of the Bracket on the top side of the DIN Rail first.
2. Push the bottom of the Bracket to snap on the bottom side of the DIN Rail.
3. Hang the Data Collector on the Bracket on DIN Rail.
To release the Bracket from DIN Rail, please follow the steps below.
1. Take out the Data Collector from the Bracket on DIN Rail.
2. Insert a flathead screwdriver into the rectangular slot and turn it downward to release the clip
from the DIN Rail.
3. Remove the Bracket from the DIN Rail.
The installation must be done by qualified installers and/or licensed electrician according to the applicable
local regulations.
The connection of Micro Inverter System to the electricity distribution network must be approved by the
appropriate electrical distributor.
The installation must be carried out while the equipment is disconnected from the grid.
Step 3
Released
Step 1
Step
Step 3
Step 1
Step 2
Ste
p
2