User Manual Chapter 3

3-6
Diskette Drives
When you select this option, a dialog box will pop up allowing you to set the
types of diskette drives used with your system. You can set the diskette drive
type to None, 1.44 MB, or 2.88 MB. The internal diskette drive is by default
referred to as Drive A.
Internal HDC
You can either enable or disable this option. Set this option to enable in order
to use the internal hard disk drive.
IDE Settings
When you select this option, a dialog box will pop up allowing you to set the
IDE settings for the internal hard disk drive.
HDD Timing
This box allows you to select the speed of the internal hard disk drive. Leave
this item at the default value, unless you change the internal hard disk drive. In
that case, refer to the documentation that comes with the new disk drive to find
the proper value for this item.
I/O 32 bit transfer
This field allows you to enable or disable 32 bits transfer mode while reading
and writing to the internal hard disk drive.
HDD Block transfer
This field allows you to enable or disable block transfer while reading and
writing to the internal hard disk drive.