User's Manual Chapter 6

6-9
5. If both sockets are occupied by SODIMMs, and you want to change one or
both of the SODIMMs for a higher capacity module, locate the locking
latches at each side of the socket. Pull these locking latches outwards. This
will allow the socket and module to pop up to an angle of about 20
degrees. You can then slide the module out of the SODIMM socket.
Figure 6-6: Removing a Memory Module
6. Hold the new module at the same angle as the socket and slide the edge
connector side of the module into the socket. The edge connector has a
cutout and the socket has a notch so that it can only be installed in the
correct way. Press the module into the socket until you can no longer see
the gold-teeth of the edge connector.
Figure 6-7: Inserting a Memory Module
7. Press the module down into the memory compartment so that the locking
latches on either side of the socket engage, and hold the card down flat
inside the compartment.
8. Replace the memory compartment cover and secure it with the locking
screw.