User's Manual Chapter 8

B-3
1. Turn on your system and go to DOS mode, i.e. your hard disk must at least
have been formatted before you can install any drivers.
2. Insert the support floppy disk in the floppy disk drive.
3. At the DOS prompt, type the following command:
A:\CD-ROM\install
(Where A represents the floppy disk drive)
Then press the Enter key.
4. The proper drivers will be installed on your notebook’s hard disk. When
the installation is finished, remove the floppy disk, and then reboot the
system. Next time you start the notebook, you should be able to read from
the CD-ROM drive.
Driver Installation Program
If you ever need to reinstall the device drivers (e.g. after hard disk failure…),
you can use the driver installation program on the support CD that will
automatically install all the necessary drivers for you.
To access the device driver installation program:
1. Place the support CD in the CD-ROM drive.
2. If the installation program fails to start after 20 seconds, click on the Start
menu, select RUN, and type:
D:\Setup.exe
(Where D represents the CD-ROM drive)
Then press the Enter key.
3. A window screen will pop up, with a menu bar on the left.
4. Click the check boxes of the drivers you want to install, then click [Select
Install]. This will install all the drivers you previously marked. You can
also install individual drivers by clicking the button area of a menu item.
This will only install that particular driver.
5. After you click the button, the installation program for that particular
driver will start and might prompt you for some input. Follow the screen
instructions to finish the installation.