User manual

9
Address Setting Content Explanation
Dual Loop output
control are used
100FH 0
Dead band setting
when Dual Loop
output control are
used
-999~9999, unit: 0.1 degree or 1EU
1010H 0
Hysteresis setting
value of the 1st
output group
0~9999, unit: 0.1 degree or 1EU
1011H 0
Hysteresis setting
value of the 2nd
output group
0~9999, unit: 0.1 degree or 1EU
1012H 0
Output value read
and write of Output 1
Unit: 0.1%, write is valid only under manual control
mode
1013H 0
Output value read
and write of Output 2
Unit: 0.1%, write is valid only under manual control
mode
1014H 0
Upper-limit regulation
of analog linear
output
1 scale=2.8μA=1.3mV
1015H 0
Lower-limit regulation
of analog linear
output
1 scale=2.8μA=1.3mV
1016H 0
Temperature
regulation value
－999~＋999, unit: 0.1 degree or 1EU
1020H 0
Alarm 1 type Please see the contents of the “Alarm Outputs” for
detail
1021H 0
Alarm 2 type Please see the contents of the “Alarm Outputs” for
detail
1022H 0
Auto-setting
communication flag
Auto setting ban of communication: 0, auto setting of
communication: 1
1024H 40
Upper-limit alarm 1
AL1H
Please see the contents of the “Alarm Outputs” for
detail
1025H 40
Lower-limit alarm 1
AL1L
Please see the contents of the “Alarm Outputs” for
detail
1026H 40
Upper-limit alarm 2
AL2H
Please see the contents of the “Alarm Outputs” for
detail
1027H 40
Lower-limit alarm 2
AL2L
Please see the contents of the “Alarm Outputs” for
detail
102AH
Read/Write status
b1:ALM2, b2:℃, b3:℉, b4: ALM1, b5: O2, b6:O1, b7:
AT
102CH 0
Setting of
positive/negative
proportional output
0: positive, 1: negative
102EH LED status b0: RUN,b1: ERR, b2: O2,b3: O1,b4: RX,b5:TX b6: AT
102FH Software version V1.00 indicates 0x100
1030H 0
Start pattern
number
0~7
1032H
Remaining time of
read execution
Unit: second
1033H
Remaining time of
reading execution
step
Unit: minute
1034H
Step number of
reading current
execution step
0~7