User's Manual

UM
XXXXXX
Rev 01 page
67
of
79
User Manual –I-Series 4 Slate
G-Sensor
All I-Series 4 Slate units are equipped with a g-sensor and will rotate the video based on the orientation of the device.
Debug Bridge (ADB) control (Developers Only)
Connecting to ADB
Elo device supports debugging via Wi-Fi/Ethernet or using the a separate microUSB cable(not included)
Set I-Series 4 Slate to (Developer)
 Enter Settings → About Phone → Build Number.
 Tap Build Number 7 times to enter developer mode.
 Go back to the Settings → System → Advanced and you will see “Developer Options”.
 From Developer options on- screen display, enable the option called “USB debugging”.
To connect via Wi-Fi
Ensure that your computer is online and not behind a firewall.
 Find the IP address (by going to Settings → Network & Internet → Wi-Fi →Tap the active connection → Advanced→ IP Address.
 On your host computer, use the command ADB connect <IP address> to be able to perform ADB actions.
To connect via USB
Locate the debug port on the USB-C Head as shown in the figure below.
This will require removing the head from the stand
Remove Rubber Plug and plug in MicroUSB Cable