User's Manual

UM600
xxx
Rev 01, page
74
of
79
User Manual – Elo I-Series 4
Notice to Users in Canada for IC compliance: This equipment complies with the Class B limits for radio noise emissions
from digital apparatus as established by the Radio Interference Regulations of Industrial Canada.
CAN ICES3 (B)/NMB3(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with
the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification
for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which means
that the equipment has been tested to the following Directives and Standards: This equipment has been tested to the
requirements for the CE Mark as required by EMC Directive 2014/30/ EU as indicated in European Standard EN 55032
Class B and the Low Voltage Directive 2014/35/EU as indicated in European Standard EN 62368-1.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to this
manual the equipment may cause interference with radio and television communications. There is, however, no
guarantee that interference will not occur in any particular installation due to site-specific factors.
1. In order to meet emission and immunity requirements, the user must observe the following:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturer’s approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.