User Guide

ManualsBrandsDelta Electronics ManualsOtherOPEP-33-A4K1R

OPEP-33-A4K1R

DELTA ELECTRONICS, INC.

1 Revision: S0

06/01/2007

www.deltaww.com

1.25Gbps Upstream/1.25Gbps Downstream

GE-PON ONU Transceiver

FEATURES

 RoHS compliant

 IEEE802.3ah Gigabit Ethernet compliant



2x5 pin SFF package with SC Receptacle

 1310nm Burst Mode 1.25Gbps transmitter,

and 1490nm Continuous Mode 1.25Gbps

receiver

 Integrated with WDM filter to cut 1550nm and

1650nm optical signal off

 Single +3.3V power supply

 LVPECL electrical signal interface



LVTTL Bias Control input and Rx Signal

Detect output

 Laser Class 1 Product which comply with the

requirements of IEC 60825-1 and IEC 60825-2

Description

DELTA’s GE-PON ONU transceiver

OPEP-33-A4K1R is designed for Gigabit Ethernet

Passive Optical Network transmission.

The module is contained in a 2x5 SFF

package with standard SC receptacle connector.

The module consists 1310nm DFB laser,

InGaAs PIN, Preamplifier and WDM filter in a

high-integrated optical sub-assembly, and it

receives up to 1.25Gbps of continuous data at

1490nm, and transmits 1.25Gbps of burst-mode

data at 1310nm.

Application

 IEEE 802.3ah 1000BASE-PX20-U

 GE-PON ONU

 Burst Mode Application

 FTTx WDM Broadband Access

 OPEP-33-A4K1R data link up to 20km in

9/125um single mode fiber.

Summary of content (9 pages)

PAGE 1
OPEP-33-A4K1R 1.25Gbps Upstream/1.25Gbps Downstream GE-PON ONU Transceiver FEATURES RoHS compliant IEEE802.3ah Gigabit Ethernet compliant 2x5 pin SFF package with SC Receptacle 1310nm Burst Mode 1.25Gbps transmitter, and 1490nm Continuous Mode 1.25Gbps receiver Integrated with WDM filter to cut 1550nm and 1650nm optical signal off Single +3.
PAGE 2
OPEP-33-A4K1R 1. Absolute Maximum Ratings Parameter Storage Temperature Storage Ambient Humidity Power Supply Voltage Signal Input Voltage Receiver Damage Threshold Lead Soldering Temperature/Time Lead Soldering Temperature/Time Symbol Ts HA VCC Min. -40 5 -0.3 -0.3 +7 Typ. TSOLD TSOLD Max. 85 95 4 Vcc+0.3 260/10 380/10 Unit ºC % V V dBm ºC/sec ºC/sec Note Note (1) Note (2) Note (1). Suitable for wave soldering Note (2). Only for soldering by iron 2.
PAGE 3
OPEP-33-A4K1R Note (2). These are unfiltered 20-80% values. Note (3). Measure at 27-1 NRZ PRBS pattern Note (4). Transmitter spectral limits nm 1260 1270 1280 1290 1300 1304 1305 1308 1317 1320 1321 1330 1340 1350 1360 RMS spectral width(max) 1000Base-PX20-U nm 0.72 0.86 1.07 1.40 2.00 2.42 2.55 Transmitter Spectral Limits 4 3 RMS (nm) Center Wavelength 3.00 2 1 2.53 2.41 1.71 1.29 1.05 0.88 0 1240 1260 1280 1300 1320 1340 1360 1380 Center Wavelength (nm) Note (5).
PAGE 4
OPEP-33-A4K1R 4. Specification of Receiver Parameter Input Optical Wavelength Receiver Sensitivity Input Saturation Power (Overload) Signal Detect -Assert Power Signal Detect -Deassert Power Signal Detect Hysteresis Data Output Rise/Fall time Receiver 1480 to 1500nm Reflectance Optical Isolation 1260 to 1360nm from External 1550 to 1560nm Source 1640 to 1665nm Symbol λIN PIN PSAT PA PD PA-PD tr/tf Min. 1480 -3 -44 0.5 Typ. 1490 Max.
PAGE 5
OPEP-33-A4K1R 6. Transmitter Burst Mode Timing Characteristics Parameter BiasCNT Enable Duration Interval of BiasCNT Signal Symbol Min. 1 0.112 Typ. Max. 1000000 Unit us us Note BiasCNT Enable Duration BiasCNT VccT VccT < 3.1V VccT > 3.1V Interval of BiasCNT Signal BiasCNT X Low High Data Input X X No Yes Optical Output OFF OFF Other Laser bias and modulation signal output X = Don’t care Other = Less than +7.
PAGE 6
OPEP-33-A4K1R 7. Pin Description Tx/Rx Pin No. 1 2 I/O Rx 3 O 4 5 6 7 8 9 10 O O Tx I I I Pin Name Description VeeR Receiver Ground VccR +3.3V Receiver Power Supply SD Normal Optical Input indicated by logic “High”, and No Optical Input indicated by logic “Low”. (LVTTL) RD(n) Inverted Receiver Data Output (AC-Coupled CML output) RD(p) Non-Inverted Receiver Data Output (AC-Coupled CML output) VccT +3.
PAGE 7
OPEP-33-A4K1R 8. Recommended Interface Circuit DELTA GEPON ONU Module 1uH 6. VccT 3.3V 10uF 100nF 100nF 1uH 8. BiasCNT BiasCNT Transmitter 9. TD(p) Coupled interface 10. TD(n) 7. VeeT Protocol IC 2. VccR SerDes IC 10uF 100nF 5. RD(p) Z0=50ohm 100nF 100ohm 4. RD(n) Z0=50ohm 100nF VccR RES 3. SD SD Receiver 1. VeeR * RES is the internal 4.7K to 10K Ohms pull-up resistor. DC - Coupled interface Coupled interface AC - Coupled interface 3.
PAGE 8
OPEP-33-A4K1R 9. Outline Dimensions Parameter Mechanical Dimensions Connector Type Unit mm - Description 48.3x13.5x9.6 SC/UPC connector Note IEC-61754-4 . J r e t p a h c b u S R F nC o i t 1 a 2 i t ds , c a r u d r d a o Ad D r P Fn a t rt hs e i s e aw c L sn a em 1l i r s po s mr f a l oe C Cp W eek (52W eeks/Year) : 1月 2日 =01 8 DELTA ELECTRONICS, INC. Revision: S0 06/01/2007 www.deltaww.
PAGE 9
OPEP-33-A4K1R 10. Regulatory Compliance Feature Electrostatic Discharge (ESD) to the Electrical Pins Test Method Reference Performance Human Body Model MIL-STD-883E Method 3015.7 (HBM) EIA-JESD22-A114 (1) Satisfied with Machine Model (MM) EIA-JESD22-A115 Electrostatic Discharge (ESD) to the Simplex Receptacle Contact Discharge Air Discharge Radio Frequency Electromagnetic Field Immunity IEC/EN 61000-4-2 IEC/EN 61000-4-3 electrical characteristics of product spec.