Datasheet

S24SE/S24DE series
15W Single/Dual Output DC/DC Converter
DS_S24SE/S24DE 15W _06032014 E-mail:[e-mail]
http://www.deltaww.com/dcdc
P9
For 12V signle output(Kohm):
For 15V single output(Kohm):
For example:
When need trim up to 3.4V, then the external resistor
should be 100Kohm between trim pin and Vout- pin.
When need trim down to 3.1V, then the external resistor
should be 40Kohm between trim pin and Vout+ pin.
THERMAL CONSIDERATIONS
Heat can be removed by increasing airflow over the
module. To enhance system reliability, the power
module’s case temperature should always be operated
below 105℃. If the case temperature exceeds the
maximum operating temperature, reliability of the unit
may be affected.
AIR FLOW
MODULE
Air velocity and ambient
temperature test point.
50.8mm
(2.0")
15.0mm
(0.6")
Remote on/off implementation
Output Voltage Adjustment(TRIM)
Only single output modules has output adjust function.
To increase the output voltage set point, connect an
external resistor between the TRIM pin and the
Vout(-).
To decrease the output voltage set point, connect an
external resistor between the TRIM pin and the
Vout(+).
The maximumu adjust range is ±10%, the TRIM pin
should be left open if this feature is not used.
For 3.3V single output(Kohm):
For 5V single output(Kohm):