Use and Care Manual

ELECTRICAL REQUIREMENTS – DELTA HEAT GAS GRILL

TO INSTALL AND SECURE POWER TRANSFORMER

Grill models with interior lights have a power transformer with an attached power supply cord.

This transformer must be secured in a dry location and away from the grill firebox and excessive

heat area.

a. In a base cart application, four mounting screws with nuts are provided at the bottom left rear

corner of the cart. If not provided, drill four holes using the transformer box as a template.

Secure the transformer box as shown. (Fig. 1)

b. In a built-in application secure the transformer box near the GFCI 120V outlet in a dry location

and away from the grill firebox and excessive heat area.

c. Make the transformer connections to the wire harness plug located at the left rear of the front

panel to the harness of the transformer box. (Fig. 2)

d. Plug-in the transformer’s power cord to the properly grounded GFCI 120V outlet.

e. A side burner plug to provide electrical power for side burner is located at the right rear of the

front panel. (Fig. 3)

AVERTISSEMENT

Instruction pour la mise à la terre electrique:

Cet appareil est muni d’une fiche à trois broches

(mise à la terre) afin de vous protéger des chocs

et doit être branché directement dans une prise

de courant à trois broches adéquatement mise à

la terre. Il ne faut pas couper ou enlever la

broche de mise à la terre de cette fiche.

WARNING

Electrical Grounding Instructions:

This outdoor gas cooking appliance is

equipped with a three prong (grounding) plug

for your protection against shock hazard and

should be plugged directly into a properly

grounded three prong outlet. Do not cut or

remove the third prong from this plug.

Fig. 1

ROTISSERIE MOTOR: (Motor Specification: 40 lbs. / in; 0.5A; 15W; 60 Hz.)

The rotisserie motor requires 120 volt supply. Simply plug the motor into a properly grounded

GFCI 120 volt outlet at either side of the grill.

Fig. 2

Fig. 3