User's Manual

9594

4. Select the “TCP/IP” tab (3). Next to “Configure” (4), you should

see “Manually” or “Using DHCP”. If you do not, check the

PPPoE tab (5) to make sure that “Connect using PPPoE” is NOT

selected. If it is, you will need to configure your Router for a

PPPoE connection type using your user name and password.

5. If “Manually” is selected, your Router will need to be set up

for a static IP connection type. Write the address information

in the table below. You will need to enter this information into

the Router.

6. If not already selected, select “Using DHCP” next to “Configure”

(4), then click “Apply Now”.

Your network adapter(s) are now configured for use with the Router.

Manually Configuring Computer Network Settings