User's Manual

ManualsBrandsDelta Networks ManualsElectronicsTI ZigBee communication module

SGCM-W50 User Manual

DNI Smart Grid Communication Module series

Rev. 1.0

2014/11/12

Notice:

1. Delta Networks Inc. reserves the right to change specifications detailed in this document at any time without notice,

and assumes no responsibility for any errors within this document.

2. This document contains proprietary technical information in which is the property of the Delta Networks inc. and

shall not be disclosed to others in whole or in part, reproduced, copied, or used as the basis for design,

manufacturing, or sale of apparatus without written permission of Delta Networks Inc.

Summary of content (9 pages)

PAGE 1
SGCM-W50 User Manual DNI Smart Grid Communication Module series Rev. 1.0 2014/11/12 Notice: 1. Delta Networks Inc. reserves the right to change specifications detailed in this document at any time without notice, and assumes no responsibility for any errors within this document. 2. This document contains proprietary technical information in which is the property of the Delta Networks inc.
PAGE 2
Table of Content 1. 2. PRODUCT OVERVIEW ........................................................................................................................................... 1 1.1. GENERAL DESCRIPTION ......................................................................................................................................... 1 1.2. FEATURES ..................................................................................................................................................
PAGE 3
1. Product Overview 1.1. General Description DNI Communication module – SGCM-W50 is a ZigBee communication module based on TI CC2538 SoC solution, which combines a powerful ARM Cortex M3-based MCU and a low power IEEE 802.15.4 radio. In order to increase the application feasibility of SGCM-W50 module, a PA TI CC2592 is adopted to provide +20dBm transmit power for some long distance transmission requirements, especially for applying in outdoor environment.
PAGE 4
2. Pin assignment 2.1. 2 × 5 pin connector Figure 2 SGCM-W50 2x5 connector.
PAGE 5
2.2. Connect antenna to IPEX Figure 3 SGCM-W50 IPEX. Antenna PCB External 2.3. Description Connect IPEX1 and IPEX2 using cable coaxial Connect external antenna using IPEX2 LED Figure 4 SGCM-W50 LED.
PAGE 6
3. Software architecture We can provide two different roles of SGCM-W50, one is Coordinator Communication Module and the other is Terminal Communication Module. The module is provided with TI ZigBee Pro Stack or IEEE802.15.4 Stack. The module will handle network formation, network join, routing, data transmission, data forwarding, and etc. Users can implement UART protocol between user device and the module, and application protocol between CCM and TCM. Figure 5 SGCM-W50 software architecture.
PAGE 7
4. Revision History Revision 1.0 Date 2014/11/12 By Whom YaoChing Hsieh 1st released.
PAGE 8
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 9
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.