User's Manual

VCB-5003L6-W User Manual

FCC Statement of WWAN Module

According to the definition of mobile and fixed device is described in Part 2.1091(b),

this device is a mobile device.

And the following conditions must be met:

1. This Modular Approval is limited to OEM installation for mobile and fixed applications only.

The antenna installation and operating configurations of this transmitter, including

any applicable source-based time-averaging duty factor, antenna gain and cable loss

must satisfy MPE categorical Exclusion Requirements of 2.1091.

2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and

the user’s body and must not transmit simultaneously with any other antenna or transmitter

except the WLAN transmitter included this module.

3. A label with the following statements must be attached to the host end product: This device

contains FCC ID: XMR201707BG96.

4. To comply with FCC regulations limiting both maximum RF output power and human

exposure to RF radiation, maximum antenna gain (including cable loss) must not exceed:

❒LTEB1/B2/B3/B4/B5/B8/B12/B13/B20/B26/B28<4dBi

❒GSM 850/900/1800/1900<4dBi

5. This module must not transmit simultaneously with any other antenna or transmitter

6. The host end product must include a user manual that clearly defines operating

requirements and conditions that must be observed to ensure compliance with current FCC

RF exposure guidelines.

For portable devices, in addition to the conditions 3 through 6 described above, a separate

approval is required to satisfy the SAR requirements of FCC Part 2.1093.

If the device is used for other equipment that separate approval is required for all other

operating configurations, including portable configurations with respect to 2.1093 and

different antenna configurations.

For this device, OEM integrators must be provided with labeling instructions of finished

products. Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:

A certified modular has the option to use a permanently affixed label, or an electronic label.

For a permanently affixed label, the module must be labelled with an FCC ID -Section

2.926 (see 2.2 Certification (labeling requirements) above). The OEM manual must provide

clear instructions explaining to the OEM the labeling requirements, options and OEM user

manual instructions that are required (see next paragraph).