User's Manual

TTS Bulb Configuration Weight Standard Carton
Spot / Flood TBD 1
Spot / Flood TBD 1
SEARCHLIGHT FUNCTION AND OPERATION
The advantage of the Remote Control is that it allows you to direct
the light in the best location for maximum effectiveness. They are an
increasingly popular addition on power boats, help. Secondary
remote control kits can be bought for most models which allow con-
trol from either the flybridge or main helm.
Horizontal Range
The horizontal range for this light is a con-
tinuous 360 degrees. There is no hard stop
on this light.
Vertical Range
The vertical range for this light is 70
degrees. This means you have 35 degrees
from the horizontal in both the up and down
ward motion of the light.
Auto Sweep
With the light on in either fast or slow mode,
pushing this button will continuously sweep
the light 10 degrees each side of the initial
target spot. If the light was in fast mode
when hitting the sweep button the light will
automatically place the unit into slow mode.
Simply press the auto sweep button again
to finish the cycle. The light will return to its
initial starting point and the directional con-
trols will become available for use again
.
Speed
The 233SL has the option to run the light in
all motion axis’s in FAST or SLOW mode.
For fast simply hit the Hare button, and for
slow hit the Tortoise Button.
Spot / Flood
The spot and flood buttons allow you to
change the beam configuration from a spot
to a flood, and allow you to choose any
beam configuration you desire between
these two extreme limits. Simply hold one of
the buttons down until you reach your
desired beam configuration. For full spot
simply hold the spot button down until it
comes to a hard stop. Likewise for flood.
8 Way Controller
The 8 way controller allows for easier and
faster location of an object due to the
ability to move this light in any of the
diagonals.
INSTALLATION & SET UP INSTRUCTIONS
The installation instructions will take you through 3 stages of instal-
lation and set up. These stages will be as follows
1: Mounting the light
2: Mounting the contoller
3: Learning the controller to the light
Further information is included on page 3 of this data booklet on the
controller features and the process required to install additional
control stations to this light.