User manual

Geo Brick Hardware Reference Manual
96 Appendix C
E25-28: Select Encoder Index input or AENA output (channels 1-4)
E Point and
Physical Layout
Description Default
E25:
No Jumper for TTL Level input for Ch1 Index signal (C)
Jumper 1-2 to output AENA1 at Ch1 encoder connector
No jumper installed
E26:
No Jumper for TTL Level input for Ch2 Index signal (C)
Jumper 1-2 to output AENA2 at Ch2 encoder connector
No jumper installed
E27:
No Jumper for TTL Level input for Ch3 Index signal (C)
Jumper 1-2 to output AENA3 at Ch3 encoder connector
No jumper installed
E28:
No Jumper for TTL Level input for Ch4 Index signal (C)
Jumper 1-2 to output AENA4 at Ch4 encoder connector
No jumper installed
E35-39: Select Encoder Index input or AENA output (channels 5-8)
E Point and
Physical Layout
Description Default
E35:
No Jumper for TTL Level input for Ch5 Index signal (C)
Jumper 1-2 to output AENA5 at Ch5 encoder connector
No jumper installed
E36:
No Jumper for TTL Level input for Ch6 Index signal (C)
Jumper 1-2 to output AENA6 at Ch6 encoder connector
No jumper installed
E37:
No Jumper for TTL Level input for Ch7 Index signal (C)
Jumper 1-2 to output AENA7 at Ch7 encoder connector
No jumper installed
E38:
No Jumper for TTL Level input for Ch8 Index signal (C)
Jumper 1-2 to output AENA8 at Ch8 encoder connector
No jumper installed
On the revisions of the Geo Brick that the S1- Reset button was not on the face plate
E3: Re-Initialization on Reset Control
E Point and
Physical Layout
Description Default
Remove jumper for normal reset mode (default).
Jump pins 1 to 2 for re-initialization on reset.
No jumper installed