User's Manual

Turbo PMAC2 PCI Ultralite HRM
`
E-Point Jumpers 14
E0: Reset Lock Enable
E-Point and
Physical Layout
Location
Description
Default
E0
A-7
Remove jumper for normal operation
Jump pins 1 to 2 to force the card to stay in the reset
state.
No jumper installed
E1: Card 0 (Clock Direction) Select
E-Point and
Physical Layout
Location
Description
Default
E1
A-2
Remove jumper to specify that this PMAC is Card
0, which generates its own phase and servo clock
(default).
Jump pins 1 to 2 to specify that this PMAC is not
Card 0, but Card 1 to F (15), which requires external
phase and servo clock signals from the serial port to
operate.
No jumper installed
E2: 40/60 MHz Operation
E-Point and
Physical Layout
Location
Description
Default
E2
A-2
Remove jumper.
Jump pins 1 to 2.
No jumper installed
E3: Re-Initialization on Reset Control
E-Point and
Physical Layout
Location
Description
Default
E3
A-2
Remove jumper for normal reset mode (default).
Jump pins 1 to 2 for re-initialization on reset.
No jumper installed
E4-E6: (Reserved for Future Use)