Operating Guide

ManualsBrandsDelta ManualsKitchen Faucets11949-SS-DST

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta

usted necesitará:

•LEER TODASlasinstruccionescompletamente

antesdeempezar.

•LEER TODOSlosavisos,cuidados,e

informacióndemantenimiento.

For easy installation of your Delta

faucet you will need:

•ToREAD ALLtheinstructionscompletely

beforebeginning.

•ToREAD ALLwarnings,care,andmaintenance

information.

Pour installer votre robinet Delta

facilement, vous devez:

•LIRE TOUTESlesinstructionsavantdedébuter;

•LIRE TOUSlesavertissementsainsiquetoutes

lesinstructionsdenettoyageetd’entretien.

Models/Modelos/Modèles

11949-DST

Series/Series/Seria

Savile

8/26/14   Rev.C

MEETSOREXCEEDS—ASMEA112.18.1/CSAB125.1

ALCANZAOEXCEDELASSIGIENTESNORMAS—

ASMEA112.18.1/CSAB125.1

WARNING: THIS FAUCET IS NOT TO BE USED WITH PORTABLE

DISHWASHERS!/ADVERTENCIA: ¡SESTALLAVENOSEDEBEUTILIZAR

CONMAQUINASLAVAPLATOSPORTATILES!/AVERTISSEMENT: ONNE

DOITPASBRANCHERUNLAVE-VAISSELEPORTATIFSURCEROBINET!

LEROBINETESTCONFORMEOUSUPÈRIEURAUXEXIGENCESDES

NORMESSUIVANTES:ASMEA112.18.1/CSAB125.1

SINGLE HANDLE KITCHEN FAUCETS

LLAVE DE COCINA DE PALANCA

ROBINET DE CUISINE À UNE MANETTE

1/8"

73044

www.deltafaucet.com

Summary of content (12 pages)

PAGE 1
SINGLE HANDLE KITCHEN FAUCETS LLAVE DE COCINA DE PALANCA ROBINET DE CUISINE À UNE MANETTE 73044 Models/Modelos/Modèles 11949-DST Series/Series/Seria Savile® Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.
PAGE 3
5 6 4 1 3 2 Maintenance If faucet exhibits very low flow: A. Remove aerator (1) with supplied wrench (2) and clean , or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (4) is tightened securely with a wrench.* If faucet leaks from under handle: Remove handle (5) and unthread trim cap (6). Using a wrench, ensure bonnet nut (4) is tight. Cleaning and Care If faucet leaks from spout outlet–SHUT OFF WATER SUPPLIES. Replace valve cartridge (3).
PAGE 4
Model / Modelo / Modèle 11949-DST RP50786▲ Button Botón Bouton RP40650 Set Screw Tornillo de Presión Vis de calage ▲ Specify Finish Especifíque el Acabado Précisez le fini RP63196▲ Lever Handle Manijas de Palanca Manette RP51502▲ Cap Casquete Embase RP70718 1.
PAGE 5
1 5 3 4 3 6 8 2 1 7 9 Place gasket (1) into groove on bottom of base ring (2). Place base ring onto sink over mounting hole, then install trim ring (3) over base ring. Tabs (4) on trim ring and base ring should be aligned together at the front and rear of the installation hole. Insert faucet lines and shank through mounting hole, then install hub (5) onto trim ring. Ensure that tabs on trim and base rings are correctly located in slots on bottom of hub.
PAGE 6
Optional / Opcional / Facultative 5 1 2 4 3 6 4 7 6 8 Optional Escutcheon Installation For installations using the 10" escutcheon, be certain and use the 10" escutcheon (1) and under cover plate (2). Remove adhesive backing from gasket (3) and attach to baseplate (2). Assemble under cover plate and escutcheon in place of single hole trim ring. Place the shanks (4) of the escutcheon/under cover plate assembly into the mounting holes of the sink.
PAGE 7
2 B. A. B-2 B-1 3 3 1 1 2 2 4 1 3 4 B-3 1 1 For Models With A Side Spray Note: If you prefer not to use side sprayer, skip this step and move to page 8. A. Mount spray support assembly (1) in far right hole in sink. HAND TIGHTEN ONLY. Insert spray hose (2) down through spray support. En los Modelos con Rociador al Costado B. Pull diverter clip (1) outward until loose; but, do not completely remove. Remove diverter cap (2) from diverter (3) and discard if installing a side spray.
PAGE 8
3 A. B. 2 1 OR 2 O 3 OU 3 4 1 1 2 2 4 A. Water Line Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (3) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 9
Incorrect Installation Instalación Incorrecta Installation Incorrecte Correct method Método Correcto Bonne méthode 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 10
4 3 1 2 2 4 Remove aerator (1) using supplied wrench (2) and move faucet handle (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. IMPORTANT: This flushes away any debris that could cause damage to internal parts. Reinstall aerator. Note: For future use, aerator wrench (2) can be clipped to the supply line after flushing faucet.
PAGE 11
5 1 2 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.
PAGE 12
Notes / Notas / Notes 12 73044 Rev.