Instruction manual

ASSEMBLY INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE OWNER’S

MANUAL.

Fig. 3

ASSEMBLING RAISING

AND LOWERING HANDLE

1. Assemble hub of handle assembly (A) Fig. 3, to end

of pinion shaft (B) and fasten handle to pinion shaft

using special screw (C) and spring (D).

Fig. 4

Fig. 5

2. Raise mortising machine head (E) Fig. 4, to the up

position by turning handle (A) clockwise. NOTE: Handle

(A) is spring-loaded and can be repositioned by pulling

out handle and repositioning it on pinion shaft (B).

ASSEMBLING

HYDRAULIC CYLINDER

1. Make sure head (A) Fig. 5, is held in the up position

and assemble the hydraulic cylinder (B) to the two

fittings (C), one located on the column and the other on

the back of the head.