Specification Sheet

Electronic Faucets
Wallmount Gooseneck Spout with Integral Sensor in
Base
Model No: 1500T4670-R35
SPECIFICATION:
•
Infrared electronic handwash system
•
H²Optics® technology- no external adjustments required
•
Chrome plated wallmount one piece CAST main body with Integral sensor
and rigid spout
•
Adjustable sensing range and timeout
•
Spout: R35 - Smooth End Gooseneck spout - 6.0" radius - 8.3" height
(unmounted) - Standard rigid installation - Vandal resistant .090" wall
thickness (R35SE)
•
Outlet#: 7 - Smooth Spout End with Laminar Flow Control in Spout Base -
1.5 USGPM (5.7L/min)
•
Fixed Wallmount Gooseneck Spout (R5) with Integral Sensor in Base
•
(24 VAC) Hardwire powered by Class II transformer (purchased separately)
•
Hardwire Version comes complete with watertight connector and Hardwire
Converter 24VAC to 6VDC
•
Optional battery backup available
•
Plastic SURFACE Mount Housing-REQUIRES SINGLE TEMPERED
WATER SUPPLY
•
Forged brass solenoid valve
COMPLIES WITH:
•
CSA certified.
•
Complies to ASME A112.18.1
•
ADA compliant and meets Handicapped Accessibility Standard ASME
A117.1 of less than 5 lbs handle operating force
•
US Patent #6, 826, 455
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
For optimum performance of this product, we recommend a system
pressure between 20 and 80 psi static. This product will operate up to a
maximum of 125 psi static per ANSI and CSA requirements. However, we
do not recommend pressures above 80 psi. Thermal expansion or leaking
pressure reducing valves may require use of expansion tanks or relief
valves to ensure your system never exceeds its maximum intended
pressure setting.
•
Hands free (touchless) operation.
•
Water flows when sensor is activated.
•
Water flow stops upon de-activation of sensor.
•
Auto shut-off feature that is selectable between 15 to 75 seconds. Factory
set to 45 seconds. Will reset once obstruction is removed.
•
Adjustable sensing distance 76 to 381 mm (3" to 15"). Factory set to 229
mm (9.0" +/- 1.0").
OPERATION:
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced March 05, 2012.
- 1.0.19275
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]