Installation Sheet

ManualsBrandsDelta ManualsCommercial ProductsDelta Commercial 1.5 GPM Single Hole Battery Operated Electronic Faucet with Gooseneck Spout - Less Rough-In Valve

Page 1

206441 Rev. A

Write purchase model number here for future reference

PLEASE LEAVE this M&I Sheet with the owner, maintenance plumber, etc. as

items relating to ongoing maintenance suggestions and procedures are included.

*Package Quantities May Change.

Check the Parts section of the latest Delta Commercial Faucet Price List for current quantities.

OPTION LIST

060637A

1.5 GPM (5.7 L/min)

VR Laminar Outlet with

Antimicrobial by Agion

060639A

1.5 GPM (5.7 L/min)

VR Flow Control Aerator

& Wrench

060564A

Single Hole Deck

Gasket (6/pkg)

RP6087

Nut & Washer

TRANSFORMERS

060704A

Transformer 110 to 24 VAC 20VA

up to 5 Electronic Valves

060771A

Transformer 110 to 24 VAC 40VA

up to 10 Electronic Valves

060772A

Transformer 110 to 24 VAC 100VA

up to 25 Electronic Valves

DECK PLATES

060546A

4” Deck Plate & Hold-Down Pkg

060547A

8” Deck Plate & Hold-Down Pkg

Note: See page 3 for parts breakdown

on recessed mount boxes.

RP6092

Deck Plate Nut & Washer

060546A

4” Deck Plate & Hold-Down Package

060547A

8” Deck Plate & Hold-Down Package

060564A

Single Hole Deck Gasket (6/pkg)

206441 206441 206441 206441 206441

206441 206441

206441 206441 206441

NOTE: Control Box #0 and #1 are designed for routine 171°F (77°C)

disinfection cycles up to 30 minutes.

Control Box #8 is not recommended for high temperature disinfection

cycles as the thermostatic mixing valve limits the higher temperature

flow output.

NOTE: For optimum performance of this product, we recommend a

system pressure between 20 and 80 PSI static. This product will

operate up to a maximum of 125 PSI static per ANSI and CSA

requirements. However, we do not recommend pressure above 80

PSI. Thermal expansion or leaking pressure reducing valves may

require use of expansion tanks or relief valves to ensure your system

never exceeds its maximum intended pressure setting.

061256A

36” Cable

Extension

RP30523

Braided Hose

060683A

24VAC to 6VDC

Converter

063245A

2.2 GPM

(8.3 L/min)

063139A

0.5 GPM

(1.9 L/min)

063140A

1.5 GPM

(5.7 L/min)

Adapter with

Flow Control

for smooth

end spouts

063191A (R3)

063193A (R5)

063194A (R7)

063195A (R35)

Single-Hole Mount

Assembly including

Sensor and Hold-Down

Package and Spout

with aerator thread

www.specselect.com

150__T3__ __ __

Outlet #1

2.2 GPM (8.3 L/min)

063235A (R3)

063236A (R5)

063237A (R7)

063238A (R35)

Outlet #7

1.5 GPM (5.7 L/min)

063181A (R3)

063183A (R5)

063184A (R7)

063185A (R35)

Outlet #8

0.5 GPM (1.9 L/min)

063186A (R3)

063188A (R5)

063189A (R7)

063190A (R35)

060681A

Battery Holder

063128A

Battery Box Assembly less driver

board and battery holder

063131A

3/8” Comp Connect Nut

and Ferrile

060909A

Screen Assembly

060908A

Solenoid Holder

063127A

Solenoid Valve with 3/8”

Compression Connectors

061252A

Dual Driver

Board Masco

Optics

& Proximity

060906A

Surface

Mount Housing

060905A

Cover Gasket

Fig. 1

Single-Hole Mount

Assembly including

Sensor and Hold-Down

Package and Spout

(with smooth ends)

Summary of content (8 pages)

PAGE 1
50__T3__ __ __ Write purchase model number here for future reference 206441 060637A 206441 Fig. 1 1.5 GPM (5.7 L/min) VR Laminar Outlet with Antimicrobial by Agion® 060639A 206441 206441 Outlet #7 1.5 GPM (5.7 L/min) 063181A (R3) 063183A (R5) 063184A (R7) 063185A (R35) Outlet #8 0.5 GPM (1.9 L/min) 063186A (R3) 063188A (R5) 063189A (R7) 063190A (R35) Single-Hole Mount Assembly including Sensor and Hold-Down Package and Spout (with smooth ends) 1.5 GPM (5.
PAGE 2
Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION AND SET UP INSTRUCTIONS FOR SURFACE MOUNT HOUSING: CONTROL BOX #0 STEP 1. FAUCET INSTALLATION Connect 20” braided hose to spout inlet. Clean deck/sink surface where faucet will be mounted. Mount faucet to sink using nut(s) and washer(s) provided.
PAGE 3
Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 STEP 1. ROUGH IN Note: Wires connecting between box(es) and from transformer must be protected from abrasion, and being pulled at connections. They also may have to be fished through at a later stage of construction.
PAGE 4
INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 Typical Installation (Recessed Mount Box) Gooseneck Spout STEP 3. CONNECT WATER SUPPLY Install sink and connect drainage to rough in. See applicable Fig. 6 or Fig. 7. Please note that the connection and fittings are supplied by the installer to connect 1/2” nominal sweat at the box outlet and 3/8” compression at the spout. Connect water supply through to spout.
PAGE 5
INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 STEP 7. TEST FOR OPERATION Operation Illustration Test for operation. If unit does not work properly, see Troubleshooting Guide on page 6. STEP 8. MAKING ADJUSTMENTS If adjustments are required. Note factory defaults for program shown in Quick Reference Chart. Otherwise, replace the driver board housing cover as the electronic product is ready for use.
PAGE 6
Function Function Setting To adjust settings, press and hold MODE (yellow pushbutton on left hand side) until the Function symbol appears. Once in Adjustment Mode, keep pressing MODE until desired Function is reached (see Quick Reference Table). To change Function Setting, press and release TOGGLE (white pushbutton on right hand side) until desired Function Setting is reached (see Quick Reference Table). Note: Will leave Adjustment Mode after 5 seconds.
PAGE 7
CARE INSTRUCTIONS This Delta Commercial faucet is designed and engineered in accordance with the highest quality and performance standards. With proper care, it will give years of trouble free service. Care should be given to the cleaning of this product. Although the chrome finish is extremely durable, it can be DAMAGED by ACIDIC CLEANERS (i.e. cleaners designed specifically for vitreous china lavatories and water closets), HARSH ABRASIVES or POLISH.
PAGE 8
Delta Commercial Faucet Limited Warranty All parts of the Delta® HDF® and TECK® faucets are warranted to the original consumer purchaser to be free from defects in material, finish and workmanship for a period of five (5) years unless otherwise specifically stated in the catalogue and price book. This warranty is made to the original consumer purchaser and shall be effective from date of purchase as shown on purchaser’s receipt.