Operating Guide

ManualsBrandsDelta ManualsKitchen Faucets16957-SPSD-DST

07/10/2020 Rev. B

Failure to read these instructions prior to installation may result in personal

injury, property damage, or product failure. Manufacturer assumes no

responsibility for product failure due to improper installation.

CAUTION

Read all instructions prior to installation.

L’omission de lire les présentes instructions avant l’installation peut

entraîner des blessures, des dommages matériels ou le bris du produit. Le

fabricant se dégage de toute responsabilité à l’égard d’un bris du produit

causé par une mauvaise installation.

AVERTISSEMENT

Veuillez lire toutes les instructions avant l’installation.

El no leer estas instrucciones de instalación puede resultar en lesiones

personales, daños a la propiedad, o falla en el funcionamiento del producto.

El fabricante no asume ninguna responsabilidad por la falla del producto

debido a una instalación incorrecta.

ADVERTENCIA

Lea todas las instrucciones antes de hacer la instalación.

SILICONE

Icons

1/8"

Image is for reference only.

La imagen es sólo para referencia.

L’image est fournie à titre indicatif seulement.

You may need:

Usted puede necesitar:

Articles dont vous pouvez avoir besoin :

1-877-355-2721

consumercare@deltafaucet.com

To reference replacement parts and access additional

technical documents and product info,

visit www.deltafaucet.com

Para referencia sobre las piezas de repuesto y acceder

a documentos técnicos adicionales e información del

producto, visite www.deltafaucet.com

Pour obtenir la référence des pièces de rechange ainsi

que pour avoir accès à d’autres documents techniques et

renseignements sur le produit, allez à www.deltafaucet.com

MODEL/MODELO/MODÈLE

SINGLE HANDLE & PULLOUT KITCHEN FAUCETS

LLAVES EXTRAÍBLES Y DE AGUA PARA COCINAS

ROBINETS À UNE MANETTE À BEC

DOUCHETTE ET RÉTRACTABLE POUR ÉVIERS

DE CUISINE

106558

Regístrese en línea

S’enregistrer en ligne

www.deltafaucet.com/registerme

Model number located here.

Número de modelo ubicado aquí.

Numéro de modèle situé ici.

Summary of content (12 pages)

PAGE 1
06558 SINGLE HANDLE & PULLOUT KITCHEN FAUCETS LLAVES EXTRAÍBLES Y DE AGUA PARA COCINAS ROBINETS À UNE MANETTE À BEC DOUCHETTE ET RÉTRACTABLE POUR ÉVIERS DE CUISINE MODEL/MODELO/MODÈLE Register Online Regístrese en línea S’enregistrer en ligne www.deltafaucet.com/registerme To reference replacement parts and access additional technical documents and product info, visit www.deltafaucet.
PAGE 2
Cleaning and Care Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel. Limpieza y Cuidado de su Llave Tenga cuidado al limpiar este producto. Aunque su acabado es sumamente durable, puede ser afectado por agentes de limpieza o para pulir abrasivos.
PAGE 3
1 B. A. C. A. 1 2 1 B. 3 1 2 3 1 1 3 1 2 2 2 2 Faucet Installation Faucet Installation DECK MOUNT STYLE A. Place baseplate shanks (1) through mounting holes in deck. Option: If sink is uneven, use silicone sealant under the baseplate. B. Place escutcheon (1) over baseplate. Insert faucet (2) down into escutcheon assembly. CENTER MOUNT STYLE C. Secure faucet to sink with mounting nut and washer (1). Tighten securely by hand. Using a Phillips screwdriver, tighten locking screws (2).
PAGE 4
2 B. A. B-2 B-1 3 2 1 1 2 4 3 3353-DST 4 B-3 1 2 1 For Models With A Side Spray Note: If you prefer not to use side sprayer, skip this step and move to page 5. B. Pull diverter clip (1) outward until loose; but, do not completely remove. A. Mount spray support assembly (1) in far right hole in sink. HAND TIGHTEN Remove diverter cap (2) from diverter (3) and discard if installing a side spray. Keeping the diverter clip pulled out, insert spray hose nipple (4) into diverter.
PAGE 5
3 B. A. OR 2 O 1 1 3 2 3 OU 4 A. Standard Connections B. NOTICE NOTICE To avoid risk of property damage, Follow instructions for proper installation. Failure to follow these instructions may result in risk of property damage caused by leaking at this connection. Do not use pipe dope or other sealants on water line connections. Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression. Loop tubing (2) if it is too long.
PAGE 6
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 NOTICE Failure to use plastic sleeve (ferrule) in the correct orientation will result in disconnection and possible water damage. 1. Determine desired length of supply tube (1). Leave 1" or 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (ferrule) (3) onto cut supply tube.
PAGE 7
4 A. B. 1 3 1 2 4 2 Flush Supply Lines Because your sprayer has been factory assembled to the hose, we do not recommend removing to flush the lines. Instead, if possible, we recommend placing a bucket below the outlet fitting and one of two options. 1. With the valve in mix open position (1), slowly open and close the supply stops (2). 2. With the supply stops open (2), slowly open and close the handle in the mix position (1). This will prevent debris from being lodged in the hose and sprayer.
PAGE 8
5 A. Hose Installation A. Pass hose (1) through faucet (2). Slide hose weight (3) over other end of hose. 1 Instalación de la Manguera 2 A. Pase la manguera (1) por la llave de agua (2). Enrosque el ensamble de la manga (3) en la manguera (1) para prevenir que la manguera que se atasque en le llave de agua cuando instale la pesa (4). Deslice la pesa de la manguera sobre el otro extremo de la manguera. 3 Installation du flexible A. Introduisez le flexible (1) dans le robinet (2).
PAGE 9
6 5 4 2 1 3 6 7 For Models with Soap Dispenser Remove nut (1). Insert body assembly (2) through selected hole in sink. Secure body assembly to sink with nut (1). From under the sink screw the bottle (3) onto the body assembly shank. Insert pump (4) down into the body assembly, then attach head assembly (5) to pump. NOTE: To fill, lift the head and pump assembly out of the bottle and pour not more than 8 oz. into bottle. DO NOT remove bottle each time as this weakens the neck.
PAGE 10
7 1 2 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.
PAGE 11
1/8" 4 1/8" 5 3 4 1 5 2 3 6 Maintenance If faucet exhibits very low flow: A. Remove and clean Aerator (1) with supplied wrench (2), or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (5) is tightened securely with a wrench.* If faucet leaks from under handle: Remove handle and unthread trim cap (4). Using a wrench, ensure bonnet nut (5) is tight. If leak persists: SHUT OFF WATER SUPPLIES. Replace valve cartridge (3).
PAGE 12
Limited Warranty on Delta® Faucets Parts and Finish. All parts (other than electronic parts and batteries) and finishes of Delta® faucets purchased from authorized Delta sellers are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.