Manual

4. Fig. 21, illustrates the table alignment pin (B)

removed. Loosen table locking bolt (D) Fig. 21, tilt table

to the desired angle and tighten bolt (D). When returning

table to the level position, replace table alignment pin

(B). This will automatically position the table surface at

90 degrees to the spindle.

5. A tilt scale (E)and pointer (F) Fig. 22, are provided

on the table bracket casting to indicate the degree of tilt.

SPINDLE SPEEDS

Fig. 21

Fig. 22

Twelve spindle speeds are available on the drill press. Fig. 23, illustrates the speeds and which steps of the pulleys the

belts must be positioned to obtain the 12 speeds.

SPINDLE CENTER MOTOR

540

360

250

_1090 _

590

410

1280

,_ 650

iil_

2180 _........................................................._

1450

Fig. 23