Instructions / Assembly

17
On the inside of the shower, hold the center divider (E)
against the bottom track and slide the doors (F) from wall
to wall. If the doors bind, refer to step 31 for the adjustment
procedure. NOTE: Center dividers come with one or two
holes and screws.
En el lado interior de la ducha, sujete la guía divisora central
(E) contra el riel inferior y deslice las puertas (F) de pared a
pared. Si las puertas se traban, consulte el procedimiento
de ajuste descrito en el paso 31. NOTA: Los separadores
centrales vienen con uno o dos orificios y tornillos.
37
F
E
F
Drill a 1/8" pilot hole into the bottom track through
center divider (E).
Taladre un orificio piloto de 1/8" en el riel inferior a
través de la guía divisora central (E).
Secure the center divider (E) with one or two self-
tapping screws (DD) depending on center divider
design. IMPORTANT: DO NOT overtighten.
Asegure el separador central (E) con uno o dos tornillos
autorroscantes (DD) según el diseño del separador
central. IMPORTANTE: NO apriete excesivamente.
1/8"
38
E
1
1
2
39
DD
x2
E
Outside the shower, use silicone sealant to seal along the
entire length of the wall jambs and the bottom track. Tool
sealant according to sealant manufacturer's instructions.
Fuera de la ducha, aplique sellador de silicona a lo
largo de toda la longitud de las jambas de pared y
del riel inferior. Trabaje el sellador de acuerdo con las
instrucciones del fabricante del producto.
40