Instruction manual

1. To check and adjust the outfeed roller, make a gauge

block of hardwood. Follow the dimensions in Fig. 20.

2. Check the knives to be certain that they were inserted

correctly (See “REPLACING KNIVES).”

3. Position the gauge block (A) Fig. 21 on the table

underneath the cutterhead. Insert a 0.020" feeler

gauge underneath the gauge block. Lower the head

assembly and rotate the cutterhead (follow STEP 5

under “REPLACING KNIVES,”) until one of the knives

(B) touches the top of the gauge block. Tighten the

cutterhead lock handle.

4. Remove the feeler gauge and move the gauge block

(A) Fig. 22 under one end of the outfeed roller (C).

The bottom of the outfeed roller should touch the top

of the gauge block.

5. To adjust the outfeed roller, loosen the locknut (D) Fig. 22 and use a hex wrench to turn the adjusting screw (E) until

outfeed roller touches the gauge block (A). Tighten the locknut.

6. Repeat this adjustment on opposite side of the outfeed roller.

1. Place a straight edge (B) Fig. 19 on the planer table

with one end of the straight edge extending out over

the infeed table extension (A). Check to see if the

table extension is level with the planer table on both

sides of table extension.

2. If an adjustment is necessary, loosen the locknut (D)

and adjust the stop screw (E) on each side of the

table (A). When they are level, tighten the locknut.

NOTE: If necessary, loosen the three screws (C), adjust the table extension, and tighten the screws (C).

3. Adjust the opposite side of the table extension (A).

4. Check and adjust other table extension.

LEVELING TABLE EXTENSIONS

DISCONNECT MACHINE FROM POWER

SOURCE!

For optimum performance, level the table extensions,

one of which is shown at (A) Fig. 19, with the

planer table. To check and adjust:

ADJUSTING THE HEIGHT OF THE OUTFEED ROLLER

Fig. 19

Fig. 20

Fig. 21

Fig. 22

DISCONNECT MACHINE FROM POWER

SOURCE!