Measurement Guide

Delta Shower Door
Measurement Guide
Need Additional Assistance with Delta Shower Doors?
Call us at 1.800.964.4850
Visit us at www.deltashowerdoors.com
Email us at [e-mail]
©2022 LHMC, A Masco Company
**Disclaimers
• For ceramic tile application, use the top of the tile
for the maximum door height.
• In older homes the opening at the top is often wider
than the bottom due to an out-of-plumb condition.
• NOTE: All Delta Shower Doors are designed to
accommodate out-of-plumb conditions totaling 3/8”.
RECORD DIMENSIONS BELOW
A
B
B
Pivoting Shower Doors
Choosing the right Shower Door is as easy as 1-2-3. But before you customize your dream door, you need
to make sure you have the correct measurements:
Identify Vertical and Horizontal Openings with Threshold Depth
Height (A), Widths (B), and Depth (C). Widths (B) measurements are often not the
same so doors can be adjusted up to 3/8"
A) Vertical Opening
Measure from the top of the shower or bathtub threshold up to the top of the acrylic
(or tile) surround wall
B) Horizontal Opening
Measure width of opening at the top and the bottom of the enclosure.
C) Threshold/Sill
Measure the depth from front to back (edge to edge) of the shower or
bathtub threshold.
Available Sizes:
• 27-30” Pivot Shower
- Fits openings 27" minimum – 30" maximum
- Finished Door Height: 64-3/4”
- Minimum Required Clearance Height for Installation: 66-3/4”
- Threshold/Sill Depth Requirement for Installation: 1-1/2”
- This door does not have a stud placement requirement
• 30-33” Pivot Shower
- Fits openings 30" minimum – 33" maximum
- Finished Door Height: 64-3/4”
- Minimum Required Clearance Height for Installation: 66-3/4”
- Threshold/Sill Depth Requirement for Installation: 1-1/2”
- This door does not have a stud placement requirement
• 33-36” Pivot Shower
- Fits openings 33" minimum – 36" maximum
- Finished Door Height: 64-3/4”
- Minimum Required Clearance Height for Installation: 66-3/4”
- Threshold/Sill Depth Requirement for Installation: 1-1/2”
- This door does not have a stud placement requirement
Opening
Height (A):
Width of
widest point (B):
Width at
narrowest point (B):