Installation Guide

ManualsBrandsDelta ManualsBathroomStryke Stainless 2-Handle 4-in Centerset WaterSense Bathroom Sink Faucet with Drain

11/01/2019 Rev. A

Failure to read these instructions prior to installation may result in personal

injury, property damage, or product failure. Manufacturer assumes no

responsibility for product failure due to improper installation.

CAUTION

Read all instructions prior to installation.

L’omission de lire les présentes instructions avant l’installation peut

entraîner des blessures, des dommages matériels ou le bris du produit. Le

fabricant se dégage de toute responsabilité à l’égard d’un bris du produit

causé par une mauvaise installation.

AVERTISSEMENT

Veuillez lire toutes les instructions avant l’installation.

El no leer estas instrucciones de instalación puede resultar en lesiones

personales, daños a la propiedad, o falla en el funcionamiento del producto.

El fabricante no asume ninguna responsabilidad por la falla del producto

debido a una instalación incorrecta.

ADVERTENCIA

Lea todas las instrucciones antes de hacer la instalación.

pSpecify Finish/Especifíque el Acabado/Précisez le Fini

1-800-345-3358

customerservice@deltafaucet.com

To reference replacement parts and access additional

technical documents and product info,

visit www.deltafaucet.com

Para referencia sobre las piezas de repuesto y acceder

a documentos técnicos adicionales e información del

producto, visite www.deltafaucet.com

Pour obtenir la référence des pièces de rechange ainsi

que pour avoir accès à d’autres documents techniques et

renseignements sur le produit, allez à www.deltafaucet.com

MODEL/MODELO/MODÈLE

TWO HANDLE BATHROOM CENTERSET

FAUCETS

LLAVES DE DOS MANIJAS DE MONTURA

DE CENTRO PARA LAVAMANOS

ROBINETS À ENTRAXE COURT À

DEUX POIGNÉES

106643

Regístrese en línea

S’enregistrer en ligne

www.brizo.com/customer-support/product-registration

Image is for reference only.

La imagen es sólo para referencia.

L’image est fournie à titre indicatif seulement.

Model number located here.

Número de modelo ubicado aquí.

Numéro de modèle situé ici.

You may need:

Usted puede necesitar:

Articles dont vous pouvez avoir besoin :

Summary of content (12 pages)

PAGE 1
06643 MODEL/MODELO/MODÈLE pSpecify Finish/Especifíque el Acabado/Précisez le Fini TWO HANDLE BATHROOM CENTERSET FAUCETS LLAVES DE DOS MANIJAS DE MONTURA DE CENTRO PARA LAVAMANOS ROBINETS À ENTRAXE COURT À DEUX POIGNÉES Register Online Regístrese en línea S’enregistrer en ligne www.brizo.com/customer-support/product-registration To reference replacement parts and access additional technical documents and product info, visit www.deltafaucet.com Model number located here. Número de modelo ubicado aquí.
PAGE 2
Cleaning and Care Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel. Limpieza y Cuidado de su Llave Tenga cuidado al limpiar este producto. Aunque su acabado es sumamente durable, puede ser afectado por agentes de limpieza o para pulir abrasivos.
PAGE 3
1 2 A. A. 1 2 4 3 1 B. 2 1 3 4 2 A. Remove tube (1) from end slot and fully unwind tube. Repeat for other side and then move handles to the off position. A. Slide gasket (1) up over tubes and mounting shanks. Install under faucet body (2). Place tubes through mounting holes and slide faucet down until it rests on mounting surface. Note: If mounting surface is uneven, use silicone under the gasket.
PAGE 4
3 B. A. OR 2 O 1 1 3 2 3 OU 4 A. Standard Connections B. NOTICE NOTICE To avoid risk of property damage, Follow instructions for proper installation. Failure to follow these instructions may result in risk of property damage caused by leaking at this connection. Do not use pipe dope or other sealants on water line connections. Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression. Loop tubing (2) if it is too long.
PAGE 5
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 NOTICE Failure to use plastic sleeve (ferrule) in the correct orientation will result in disconnection and possible water damage. 1. Determine desired length of supply tube (1). Leave 1" or 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (ferrule) (3) onto cut supply tube.
PAGE 6
C 1 2 3 CONNECT TO WATER SUPPLIES. (HOOK-UPS NOT PROVIDED). Determine which type of connection you will be making. Ball nose risers (1) (3/8" O.D. copper tubing) with coupling nuts (3) (not supplied) or 1/2" I.P.S faucet connectors (2). CONECTE A LOS SUMINISTROS DE AGUA. (LAS CONEXIONES NO SON PROPORCIONADAS). Determine que tipo de conexión usted va a hacer. Tubos montantes de nariz redondeada (1) (tubería de cobre de 3/8" D.E.
PAGE 7
B. C. E. D. 1 21 ( 4 A. 6, /, & 1 2 3 2 3 1 2 1 1 F. G. 4 2 2 5 H. 3 2 1 4 1 5 3 2 1 2 6 Metal Pop-up A. Remove stopper (1) and flange (2). B. Screw nut (1) all the way down. Push washer (2) and gasket (3) down. C. Remove tailpiece (1) from body (2), add plumber tape (3), replace tailpiece. D. Apply silicone to underside of flange (1). G. Remove pivot nut (1). Install horizontal rod (2) and E. Pivot (1) must face faucet. Pull assembly H.
PAGE 8
C. B. NE I CO A. SIL 1 3 3 1 2 1 2 4 4 E. D. F. 3 2 2 4 5 1 3 2 1 4 5 3 1 6 Pop-Up with Metal Flange and Plastic Tail Piece emove stopper (1), brass nut & washer (2), black A. R gasket (3) and tail piece (4). pply silicone to underside of flange (1). Insert B. A flange into sink. C. Install black gasket (1), washer and brass nut (2) onto flange (3) from below sink, but do not tighten brass nut (2). Screw on tail piece (4) and hand tighten. D.
PAGE 9
5 1 3 3 2 2 4 4 Remove aerator (1) using supplied wrench (2) and turn faucet handles (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts. Verify the seal is attached to aerator then reinstall. Note: For future use, aerator wrench (2) can be clipped to the supply line after flushing faucet. Check all connections at arrows for leaks.
PAGE 10
To Change the Position of Handle Stop (5). Para cambiar la posición de el tope (5). Pour changer la position de la butée (5). DST Valves Válvulas DST Montrées DST Cold Fría Froide Hot Caliente Chaude 10 10 8 5 5 5 6 4 7 5 3 4 9 La flecha va hacia el surtidor en lados calientes y fríos. 3 5 Arrow faces spout on both hot & cold sides. 3 1 Hot Caliente Chaude La flèche va vers le bec des côtés chauds et froids. Open/Abrir/Ouvert Cold Fría Froide Valves shown in closed position.
PAGE 11
5 4 1 Seat & Spring Cartridge Asiento y cartucho de resorte Cartouche siège et ressort 2 Maintenance SHUT OFF WATER SUPPLIES NOTE: Remove the handles by turning the handle base counter clockwise 45 degrees, then lift up. Reinstall the handles by pressing down firmly at the base of the handle assembly and turning the base clockwise 45 degrees. If faucet exhibits very low flow: Replace Cartridge Assembly (1) and Seats and Springs (2)*. If faucet leaks from spout outlet: A.
PAGE 12
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.