Full Product Manual

11
MOUNTING AND TRANSPORTATION
CARRY HANDLE
MOUNTING SAW TO STABLE SURFACE
For transportation use the included carry handle (A) as shown
in Fig. 5 You may also lift using the cast-in handle cut-outs (B)
on both sides of the saw base as shown in Fig. 5
To ensure safe and accurate operation, this
saw should be mounted to a stable and level surface such as a
workbench. To mount the tool to a stable surface, refer to
Figure 6 and do the following:
1. Locate the four mounting holes in the base of the saw
C.
2. Secure the tool to the mounting surface using 3/8”
diameter machine bolts, lock washers, and hex nuts
(not included). Make sure the bolts are long enough to
accommodate the saw base, lock washers, hex nuts,
and the thickness of the workbench.
3. Tighten all four bolts securely.
4. Check to make sure that the saw is secure before
operation.
Figure 5
Figure 6
C C
B
A
Figure 7
D
E
F
G
INSTALLING SUPPORT EXTENSIONS
To assemble the support extensions, refer to Figure 7 below:
1. Insert one of the support extensions (F) to the
underside of the base at the cast-in handle cut-outs (B)
shown in Figure 5.
2. Make sure support extension (F) is ush with the base
and inserted into the rounded slots of the cut-outs (B).
The rivets (G) are used to ensure the support extension
does not slide out of the base during use. Ensure these
rivets are positioned on the inside of the base.
3. Place the extension clamp (E) onto the support
extension and the screw that is pre-attached to the
base.
4. Once the extension clamp (E) is in place, screw the M8
hex nut provided (D) onto the screw.
5. Tighten the nut (D) with an M8 hex wrench to fully
secure the support extension.
Do not attempt to lift the miter saw by the
support extensions.