Full Product Manual

20 21

Figure 27

Figure 29

OPERATION

INCREASE CUT CAPACITY

This saw is designed to allow for large capacity cuts up to (2”

x 18”). In order to make these cuts you will need to configure

your saw appropriately.

Do not use an auxiliary table board which will

not fully support the workpiece during cutting operation.

1. Loosen the fence lock knob (A). Slide the upper

(adjustable) fence (B) completely out of its track and set

to the side. See Figure 27.

2. Flip the support tabs (C) into position. Tabs (C) are on

both the left and right sides of the lower (xed) fence.

These will function as your workpiece backstop. See

Figure 29.

3. You will need to add an auxiliary table board (D) to

support your large capacity workpiece (E). Place a 2”

x 14” auxiliary table board (D) onto the saw table and

against the lower (xed) section of the saw fence. Make

sure the board is securely positioned against the lower

(xed) fence.

NOTE: Use wood screws to secure the auxillary table board

(D) to the lower (xed) fence. See Figure 28.

4. Use the support tabs (C) to secure your workpiece

before making any cuts

LOOSEN

TIGHTEN

Figure 28